ACADEMY Summit Classic Deluxe Tripod 12 Leg Kit Manual - Halaman 4

Jelajahi secara online atau unduh pdf Manual untuk Aksesori ACADEMY Summit Classic Deluxe Tripod 12 Leg Kit. ACADEMY Summit Classic Deluxe Tripod 12 Leg Kit 8 halaman.

Halaman Cetak

1. Parts List

12' LEG

ASSEMBLY

(PN 14063.1200)

Oval hole must be

on far end of leg

assembly

LEG BRACES

1. Locate the pre-punched hole half-way down the Leg

Assembly.

2. Position one Bracket over this hole from the inside and

secure using one

2 3/4" bolt and lock nut

8. As before, the Bracket should run horizontal to the

ground when the tripod is standing up - You must run this

bolt from the inside out so that the head of the bolt is

sitting on the Bracket when tight.

3. Repeat for the other Leg Assembly and the Ladder

Assembly as shown in figure 9. Use one

nut

to secure each Bracket. You must run these bolts from

the inside out so that the head of the bolt is sitting on

the Bracket when tight.

2 3/4" BOLTS, LOCK NUTS -

WRENCH TIGHTEN

PG 4

as shown in figure

2 3/4" bolt and lock

BRACKET

(PN 14061.400)

BRACKET

(PN 14061.400)

LEG ASSEMBLY (continued)

10. Position one of the 12' Leg Assemblies as shown in

figure 6. The oval pre-punched holes MUST be on the far

end of the Leg Assembly. These holes are for the Spikes

included with the 81518 Top Section.

11. Slide the Leg Assembly into the Coupler Plate and

secure using one

2 3/4" bolt and lock nut

12. Rotate the tripod and repeat for the other Leg

Assembly.

2 3/4" BOLT, LOCK NUT -

WRENCH TIGHTEN

2 3/4" BOLT, LOCK NUT -

WRENCH TIGHTEN

BRACKET

(PN 14061.400)

as shown in figure