Kohler K-1114 Panduan Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Bak mandi Kohler K-1114. Kohler K-1114 48 halaman. Bath with airjets
Juga untuk Kohler K-1114: Panduan Pemilik Rumah (32 halaman), Panduan Pemilik Rumah (29 halaman), Panduan Instalasi (48 halaman), Panduan Pemilik Rumah (36 halaman), Manual Pengasahan Awal (Roughing-In) (4 halaman), Panduan Instalasi (44 halaman), Manual Pengasahan Awal (Roughing-In) (4 halaman), Manual Pengasahan Awal (Roughing-In) (4 halaman), Panduan Instalasi (44 halaman), Panduan Pemilik Rumah (29 halaman)

4. Secure the Unit

NOTICE: Do not lift the bath with airjets by the air channels or blower motor, or use the piping or blower

motor for structural support of the bath.

NOTICE: Do not support the bath by the rim.

Choose the installation option that best applies to your particular installation. Follow the

appropriate instructions.

If the subﬂoor is not level, shim the bath support blocks as necessary.

NOTICE: Do not use gypsum cement or drywall compound for this application, as they will not provide

an acceptable, durable bond.

Spread a 2" (5.1 cm) thick layer of cement or mortar on the subﬂoor where the bath will be set. This

will help secure, level, and support the unit. Clear all the material away from the support block

locations.

Position a piece of plastic drop cloth material on top of the cement or mortar bed.

With help, carefully lift the bath into place, and make sure the support blocks do not rest in the bed

material.

Insert the drain tailpiece into the trap. Make sure the bath is level and resting on all support blocks.

Remove the protective tape from the rim. Apply a continuous bead of high-quality silicone sealant

around the entire rim of the bath.

Allow the sealant to cure according to the manufacturer's instructions.

Apply a generous amount of high-quality construction adhesive to the bottom of the support blocks.

With help, carefully lift the bath into position.

Insert the drain tailpiece into the trap. Make sure the bath is level and resting on all support blocks.

Remove the protective tape from the rim. Apply a continuous bead of high-quality silicone sealant

around the entire rim of the bath.

Allow the sealant to cure according to the manufacturer's instructions.

Kohler Co.

Spread a 2" (5.1 cm)

layer of cement or

mortar bed material.

Clear spaces

for support

blocks.

Apply construction

adhesive to the

support blocks.

1040292-2-E