Kohler Aegis LH775 Panduan Pemilik - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Kohler Aegis LH775. Kohler Aegis LH775 12 halaman. Horizontal-shaft
Juga untuk Kohler Aegis LH775: Panduan Pemilik (21 halaman)

Halaman Cetak

Air Cleaner

NOTE: Operating engine with loose or

damaged air cleaner components

could cause premature wear and

failure. Replace all bent or damaged

components.

NOTE: Paper element cannot be blown out

with compressed air.

1. Unhook retaining clips and remove end

cap(s).

2. Check and clean inlet screen (if equipped).

3. Pull air cleaner element out of housing and

replace. Check condition of inner element;

replace when dirty.

4. Check all parts for wear, cracks, or damage,

and that ejector area is clean.

5. Install new element(s).

6. Reinstall end cap(s) with dust ejector valve/

screen down; secure with retaining clips.

Breather Tube

Ensure both ends of breather tube are properly

connected.

Air Cooling

Hot Parts can cause severe

burns.

Do not touch engine while

operating or just after stopping.

Never operate engine with heat shields or

guards removed.

NOTE: Operating engine with a restricted air

intake screen or radiator, damaged/

broken fan assembly, or missing fan

shroud will cause engine damage due

to over heating.

Proper cooling is essential. To prevent over

heating, clean screens, cooling ﬁ ns, and other

external surfaces of engine. Avoid spraying

water at wiring harness or any electrical

components. See Maintenance Schedule.

66 590 04 Rev. --

WARNING

KohlerEngines.com

Cooling System

Hot liquid can cause severe

burns.

Do not loosen radiator cap while

engine is operating or warm to

touch.

Liquid coolant can get extremely hot from

operation. Turning radiator cap when engine

is hot can allow steam and scalding liquid

to blow out and burn you severely. Shut off

machine. Only remove radiator cap when

cool enough to touch with bare hands. Slowly

loosen cap to ﬁ rst stop to relieve pressure

before removing completely.

NOTE: Do not operate engine without fan and

cooling system functioning properly, or

engine damage will occur.

This engine is liquid-cooled, circulating a

mixture of ethylene glycol and water for

dependable operation. Maintaining correct

coolant level and cleaning any debris

accumulation from inlet screen and radiator

surfaces are critical to ensuring long life,

proper system performance, and preventing

overheating. A drive belt is designed and

constructed for this application. Do not use a

substitute belt. If belt is cracked, damaged,

or adequate tension does not exist, have

necessary servicing performed by a Kohler

authorized dealer.

Drain Cooling System

1. Ensure engine is cool. When radiator is cool

to touch, slowly loosen radiator cap to ﬁ rst

stop and allow any pressure to bleed off.

Then loosen it fully and remove it.

Loosen/remove radiator drain plug and allow

coolant to drain.

2. If equipped, remove coolant drain plugs

located on each side of engine block. Drain

coolant into a suitable container. After

coolant has drained completely, apply pipe

sealant with Teﬂ on

equivalent), to threads and reinstall plugs.

Torque plugs to 325 in. lb. (36.7 N·m).

3. Remove overﬂ ow hose from reservoir.

Unhook inboard retainer and slide reservoir

out of supports. Pour out contents and wash

or clean as required. Dispose of all old

coolant in accordance with local ordinances.

4. Reinstall reservoir cap. Do not kink/pinch

hose.

5. Flush cooling system.

WARNING

(Loctite

PST

592™ or