Kohler COMMAND PRO CS10 Panduan Pemilik - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Kohler COMMAND PRO CS10. Kohler COMMAND PRO CS10 21 halaman. Horizontal crankshaft
Juga untuk Kohler COMMAND PRO CS10: Panduan Pemilik (20 halaman), Panduan Pemilik (20 halaman)

Halaman Cetak

Maintenance, repair, or replacement of the emission control devices and systems, which are being done

at the customers expense, may be performed by any non-road engine repair establishment or individual.

Warranty repairs must be performed by an authorized Kohler service outlet.

WARNING: Accidental Starts!

Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or

equipment, disable the engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-) battery

cable from battery.

Maintenance Schedule

These required maintenance procedures should be performed at the frequency stated in the table. They should

also be included as part of any seasonal tune-up.

Frequency

Daily or Before

Starting Engine

Every 25 Hours

Every 100 Hours

Annually or

Every 300 Hours

¹Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.

²Have a Kohler Engine Service Dealer perform this service.

Check Oil Level

The importance of checking and maintaining the proper

oil level in the crankcase cannot be overemphasized.

Check oil BEFORE EACH USE as follows:

1. Make sure the engine is stopped, level, and is

cool so the oil has had time to drain into the sump.

2. To keep dirt, debris, etc., out of the engine, clean

the area around the oil fill/check plug before

removing it.

3. Unthread and remove the oil fill/check plug.

4. The level should be up to but not over, the point of

overflowing the filler neck.

Maintenance Instructions

Maintenance Required

• Fill fuel tank.

• Check oil level.

• Check air cleaner for dirty, loose, or damaged parts.

• Check air intake and cooling areas, clean as necessary.

• Check fuel hose for cracks or damage. Replace if necessary.

• Check exhaust system for leakage. Retighten or replace gasket if necessary.

• Check choke operation.

• Check retractable starter operation.

• Service precleaner element. Replace if necessary.

• Change oil.

• Replace air cleaner element.

• Remove cooling shrouds and clean cooling areas.

• Check all fittings and fasteners.

• Clean fuel valve shut-off filter. Replace if necessary.

• Check muffler screen/spark arrestor. Clean/replace if necessary.

• Check spark plug condition, adjust gap, and clean. Replace if necessary.

• Check and adjust valve clearance when engine is cold.

• Check and adjust idle speed.

• Service starter motor drive, if so equipped.

• Check cooling fan for damage.

• Have combustion chamber decarbonized.

Oil Fill/

Check Plug

Figure 9. Location of Oil Drain and Check Plugs.

Oil Drain Plug