Kohler Courage PRO SV840 Panduan Pemilik - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Kohler Courage PRO SV840. Kohler Courage PRO SV840 21 halaman. Vertical crankshaft
Juga untuk Kohler Courage PRO SV840: Panduan Pemilik (21 halaman), Panduan Pemilik (8 halaman)

Kohler Courage PRO SV840 Panduan Pemilik
3. Remove the oil fill cap/dipstick; wipe oil off.
For engines with a press-on style dipstick:
Reinsert the dipstick into the tube and press all
the way down. See Figure 5.
For engines with a thread-on style dipstick:
Reinsert the dipstick into the oil fill tube and
thread the dipstick in completely. See Figures 5
and 6.
Press-On
Figure 5. Dipstick Styles.
Incorrect
Oil Fill
Cap/
Dipstick
Oil Fill
Tube
Figure 6. Thread-on Oil Fill Cap/Dipstick.
4. Remove the oil fill cap/dipstick and check
oil level. The oil level needs to be within the
operating range. See Figure 7. If low, add oil of
the proper type, up to the full mark. If oil is above
the "F" or FULL mark, drain oil to reach proper
level. Reinstall the oil fill cap/dipstick.
NOTE: To prevent extensive engine wear or damage,
always maintain the proper oil level in the
crankcase. Never operate the engine with
the oil level above the "F" or FULL mark, or
below the "L" or LOW mark on the dipstick.
Figure 7. Oil Level Marks on Dipstick (Typical).
8
Thread-On
Correct
Operating
Range
Oil Sentry™
Some engines are equipped with an optional Oil
Sentry™ oil pressure switch. If the oil pressure drops
below an acceptable level, the Oil Sentry™ will either
shut off the engine or activate a warning signal,
depending on the application.
NOTE: Make sure the oil level is checked BEFORE
EACH USE and is maintained up to the FULL
or "F" mark on the dipstick. This includes
engines equipped with Oil Sentry™.

Change Oil and Oil Filter

Change the oil and oil filter annually or every 100
hours of operation (more frequently under severe
conditions). Refill with service class SG, SH, SJ, or
higher oil as specified in the Viscosity Grades table
(Figure 2) on page 4. Always use a genuine Kohler oil
filter. Use chart below to determine part number to
order.
Oil Filter Part No.
12 050 01-S
52 050 02-S
Change the oil while the engine is still warm. The oil
will flow more freely and carry away more impurities.
Make sure the engine is level when filling, checking, or
changing the oil.
Starter
Oil Drain Plug
Figure 8. Oil Drain Plug.
Oil Filter
Figure 9. Oil Filter Location.
Length
2-1/2"
3-3/8"