Kohler Courage SV590 Panduan Pemilik - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Kohler Courage SV590. Kohler Courage SV590 17 halaman. Vertical shaft
Juga untuk Kohler Courage SV590: Panduan Pemilik (17 halaman), Panduan Pemilik (17 halaman), Panduan Pemilik (8 halaman), Panduan Pemilik (48 halaman)

Halaman Cetak
Kohler Courage SV590 Panduan Pemilik
2. Low Idle Fuel Needle Setting: Place the throttle
into the idle or slow position.
Turn the low idle fuel adjusting needle out
(counterclockwise) from the preliminary setting
until engine speed decreases (rich). Note the
position of the needle.
Now turn the adjusting needle in (clockwise). The
engine speed may increase, then it will decrease
as the needle is turned in (lean). Note the position
of the needle.
Set the adjusting needle midway between the
rich and lean settings. See Figure 15.
Adjust to
Midpoint
Rich
Figure 15. Optimum Low Idle Fuel Setting.
Possible Cause No
Improper
Problem
Fuel
Will Not Start
•
Hard Starting
•
Stops Suddenly
•
Lacks Power
Operates Erratically
Knocks or Pings
Skips or Misfires
Backfires
Overheats
High Fuel Consumption
Storage
If the engine will be out of service for two months or
more, use the following storage procedure:
1. Clean the exterior surfaces of the engine.
2. Change the oil and filter while the engine is still
warm from operation. See Change Oil and Filter
on page 9.
3. The fuel system must be completely emptied, or
the gasoline must be treated with a stabilizer to
prevent deterioration. If you choose to use a
stabilizer, follow the manufacturers
recommendations, and add the correct amount
for the capacity of the fuel system. Fill the fuel
tank with clean, fresh gasoline. Run the engine for
2-3 minutes to get stabilized fuel into the
carburetor.
Lean
Dirt In
Fuel
Fuel Line Grass Screen
•
•
•
•
•
•
•
•
•
•
•
•
•
•
3. Low Idle Speed Setting: Place the throttle control
into the idle or slow position. Set the low idle
speed to 1500 RPM* (± 75 RPM) by turning the
low idle speed adjusting screw in or out. Check
the speed using a tachometer.
*NOTE: The actual low idle speed depends on the
application – refer to equipment
manufacturer's recommendations. The
recommended low idle speed for basic
engines is 1500 RPM. To ensure best
results when setting the low idle fuel
needle, the low idle speed must not
exceed 1500 RPM (± 75 RPM).

Troubleshooting

When troubles occur, be sure to check the simple
causes which, at first, may seem too obvious to be
considered. For example, a starting problem could be
caused by an empty fuel tank. Some common causes of
engine troubles are listed in the following table.
Do not attempt to service or replace major engine
components, or any items that require special timing
or adjustment procedures. Have your Kohler Engine
Service Dealer do this work.
Dirty
Incorrect
Oil Level
Overloaded
•
•
•
•
•
•
•
•
•
•
•
To empty the system, run the engine until the
tank and system are empty.
4. Due to the deep recess around the spark plug,
blow out the cavity with compressed air. Remove
the spark plug. The spark plug is most accessible
when the blower housing is removed for
cleaning.
Add one tablespoon of engine oil into the spark
plug hole. Install the plug, but do not connect the
plug lead. Crank the engine two or three
revolutions. Connect the plug lead.
5. Reinstall the blower housing, if removed
previously, and torque the blower housing
screws to 7.5 N·m (65 in. lb.).
6. Store the engine in a clean, dry place.
Engine
Dirty Air
Cleaner
Spark Plug
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Faulty
•
•
•
•
•
•
•
•
13