Kohler 10RESVL Panduan Instalasi - Halaman 30

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Generator Portabel Kohler 10RESVL. Kohler 10RESVL 48 halaman. Residential/commercial generator sets
Juga untuk Kohler 10RESVL: Petunjuk Instalasi (2 halaman)

Halaman Cetak

1.13 Set the Exerciser

Set the exerciser to automatically run the generator set

on the desired day and time every week or every two

weeks. See the generator set Operation Manual for

detailed descriptions of the unloaded and loaded

exercise operation.

Note: Your generator will use either the RDC2 (RESV

models) or the DC2 (RESVL models) controller.

Determine which controller your generator set

uses and follow the directions to set that specific

controller. See Figure 1-28.

RDC2 (RESV)

Figure 1-28 Controller Identification

1.13.1 RDC2 Controller

When power is applied to the RDC2 controller (when the

battery or the utility power for the battery charger is

connected), you will be prompted to set the date and

time, and then to set the exerciser.

The first setting will flash. Press the Up and Down arrow

buttons to change the setting. Press Select to save the

setting and move on to the next. Repeat until the date,

time, and exercise are set and the controller display

shows the main menu. See the generator set Operation

Manual for more detailed instructions to set the date and

time and set the exerciser.

Press AUTO to place the generator set controller into

automatic mode.

Date:

05Dec2011

Time:

08:31am

Next Exercise:

08:31a 12Dec2011

Figure 1-29 Set Time, Date, and Exercise (RDC2)

Section 1 Installation

DC2 (RESVL)

Setting will flash.

Press the up and down arrow

buttons to change the setting.

Press Select to save the set-

ting.

tp6803

1.13.2 DC2 Controller

To set the exerciser on the DC2 controller, first press

AUTO to place the controller into automatic (standby)

mode. Then press and hold the Exercise button. The

generator set will start and run a 20-minute unloaded

cycle exercise. The generator set will run automatically

for 20 minutes at the same time every 7 days. See the

generator set Operation Manual for more information.

1.13.3 Loaded Exercise

In order to set a loaded exercise using the RDC2 or DC2

controller, a Kohlerr Model RXT transfer switch must be

connected. See the generator set operation manual for

instructions to set a loaded exercise.

To set a loaded exercise on a generator set connected to

a transfer switch other than a Model RXT, use the

transfer switch controller to set the exercise. Refer to the

transfer switch operation manual for instructions.

1.14 Operation Test

WARNING

Hazardous voltage.

Can cause severe injury or death.

Operate the generator set only when

all guards and electrical enclosures

are in place.

1. Verify that all guards and enclosure panels are in

place.

2. Check the items in the Prestart Checklist in

Section 1.12.

3. Press the RUN button on the generator set

controller to start the generator set. Verify that the

engine starts and runs.

4. Use a digital voltmeter (DVM) to check the output

voltage (line to line and line to neutral) from the

generator set. If voltage calibration is required,

refer voltage calibration instructions in the service

manual.

5. Press OFF to stop the engine. Then press AUTO

on the RDC2 controller.

6. Verify that the enclosure door is closed and that the

panels are installed. Lock the enclosure to prevent

unauthorized access.

Moving parts.

TP-6984

5/17a