Kohler 12RESM1 Manual - Halaman 22

Jelajahi secara online atau unduh pdf Manual untuk Generator Portabel Kohler 12RESM1. Kohler 12RESM1 36 halaman. Residential/commercial generator sets
Juga untuk Kohler 12RESM1: Panduan Instalasi (40 halaman), Panduan Instalasi (36 halaman), Panduan Pengoperasian (48 halaman), Operasi (48 halaman)

Halaman Cetak

d. Reconnect the generator set engine starting

battery, negative (--) lead last.

e. Reconnect the power to the battery charger.

f. Start and run the generator set for a minute to

allow the oil pressure to reach the operating

range.

g. Stop the generator set, wait 1 minute, and then

recheck the oil level. Add oil to bring the level

up to the F mark on the dipstick.

4. Check for leaks.

a. Check for oil leaks.

b. Fix leaks and recheck the oil level.

c. Reinstall the housing side panel.

3.4 Spark Plugs

Reset the spark plug gap or replace the plugs with new

plugs as necessary.

1. Clean the area around the base of the spark plug to

keep dirt and debris out of the engine.

2. Remove the spark plug and check its condition.

Replace the spark plug if it is worn or if its reuse is

questionable.

3. Check the spark plug gap using a wire feeler

gauge. Adjust the gap to 0.76 mm (0.030 in.) by

carefully bending the ground electrode.

Figure 3-2 and Figure 3-3.

Figure 3-2 Checking the Spark Plug Gap

Figure 3-3 Adjusting the Spark Plug Gap

Section 3 Scheduled Maintenance

3.5 Air Cleaner Element and

Precleaner

The engine has a replaceable high-density paper air

cleaner element with an oiled foam precleaner. See

Figure 3-4.

1. Cover knob

2. Air cleaner cover

3. Element cover nut

4. Element cover

5. Foam precleaner

6. Air cleaner element

See

7. Air cleaner base

Figure 3-4 Air Cleaner Components

Check for a buildup of dirt and debris around the air

cleaner system. Keep this area clean.

Note: Operating the engine with loose or damaged air

cleaner components could allow unfiltered air

into the engine causing premature wear and

failure.

1--514

3.5.1

Precleaner Service

Use the following procedure to wash and reoil the

precleaner as indicated in the service schedule. Wash

and reoil the precleaner more often under extremely

dusty or dirty conditions.

1. Place the generator set master switch in the

OFF/RESET position.

1--511

2. Disconnect the power to the battery charger.

586536

TP-6398 4/07