Kohler 12TRES Panduan Pengoperasian - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Generator Portabel Kohler 12TRES. Kohler 12TRES 36 halaman. Advanced digital control adc-res

Halaman Cetak

2.1 Prestart Checklist

To ensure continued satisfactory operation, perform the

following checks or inspections before or at each

startup, as designated, and at the intervals specified in

the service schedule. In addition, some checks require

verification after the unit starts.

Air Cleaner. Check for a clean and installed air cleaner

element to prevent unfiltered air from entering the

engine.

Air Inlets. Check for clean and unobstructed air inlets.

Battery. Check for tight battery connections. Consult

the battery manufacturer's instructions regarding

battery care and maintenance.

Exhaust System.

Check for exhaust leaks and

blockages. Check the muffler condition and check for

tight exhaust system connections.

Inspect the exhaust system components for cracks,

leaks, and corrosion.

Check for corroded or broken metal parts and replace

them as needed.

Check that the exhaust outlet is unobstructed.

Oil Level. Maintain the oil level at or near, not over, the

full mark on the dipstick.

Operating Area. Check for obstructions that could

block the flow of cooling air. Keep the air intake area

clean. Do not leave rags, tools, or debris on or near the

generator set.

2.2 Exercising Generator Set

Operate the generator set without load once each week

for 20 minutes. If the generator set is not connected to

an automatic transfer switch (ATS) with an exercise

option, exercise the unit in the presence of an operator.

The operator should perform all of the prestart checks

before starting the exercise procedure.

generator set according to the starting procedure in the

controller section of this manual. While the generator

set is operating, listen for a smooth-running engine and

visually inspect the generator set for fluid or exhaust

leaks. Check the air inlets and outlets and remove any

items restricting the air flow.

TP-6515 10/07

2.3 ADC-RES Controls and

Indicators

Figure 2-1 illustrates the ADC-RES user interface and

other items on the generator set junction box.

Figure 2-3 describes the ADC-RES controls and

indicators.

1. Select button (use for setup and adjustment only)

2. LED display

3. Up and down arrow buttons

4. Generator set master switch

5. Line circuit breaker

6. Fuses

7. RS-232 connector (for application program upgrade)

Figure 2-1 ADC-RES Controls

2.3.1

The LED display is activated by a start or RUN

command as follows:

Move the master switch to RUN.

With the master switch in AUTO, send a remote start

command (close the remote start contact across

Start the

leads 3 and 4).

The LED display indicates generator set status as

shown in Figure 2-3. When the generator set is running,

engine runtime hours are shown unless the arrow

Section 2 Operation

LED Display

xxx

Section 2 Operation