Kohler 14/20RESAL Panduan Instalasi - Halaman 34

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Generator Portabel Kohler 14/20RESAL. Kohler 14/20RESAL 44 halaman. Residential/commercial generator sets

Halaman Cetak

1.11 Prestart Installation Check

Review the entire installation section. Inspect all wiring

and connections to verify that the generator set is ready

for operation. Check all items in the following Prestart

Checklist.

Prestart Checklist

Air Cleaner. Check that a clean air cleaner element is

installed to prevent unfiltered air from entering the

engine. See the generator set operation manual for

instructions.

Air Inlets. Check for clean and unobstructed air inlets.

Battery. Check for tight battery connections. Consult

the battery manufacturer's instructions regarding

battery care and maintenance.

Enclosure.

Check that all enclosure panels and

internal baffling are in place.

Exhaust System.

Check for exhaust leaks and

blockages. Check the muffler condition.

Inspect the exhaust system components for cracks,

leaks, and corrosion. Check for tight exhaust system

connections.

Check for corroded or broken metal parts and replace

them as needed.

Check that the exhaust outlet is unobstructed.

Oil Level. Maintain the oil level at or near, not over, the

full mark on the dipstick.

Operating Area. Check for obstructions that could

block the flow of cooling air. Keep the air intake area

clean. Do not leave rags, tools, or debris on or near the

generator set.

1.12 Set the Exerciser

Set the exerciser to automatically run the generator set

on the desired day and time every week or every two

weeks. See the generator set Operation Manual for

detailed descriptions of the unloaded and loaded

exercise operation.

1.12.1 RDC2 Controller

When power is applied to the RDC2 controller (when the

battery or the utility power for the battery charger is

Section 1 Installation

connected), you will be prompted to set the date and

time, and then to set the exerciser.

The first setting will flash. Press the Up and Down arrow

buttons to change the setting. Press Select to save the

setting and move on to the next. Repeat until the date,

time, and exercise are set and the controller display

shows the main menu. See the generator set Operation

Manual for more detailed instructions to set the date and

time and set the exerciser.

Press AUTO to place the generator set controller into

automatic mode.

Date:

05Dec2011

Time:

08:31am

Next Exercise:

08:31a 12Dec2011

Figure 1-37 Set Time, Date, and Exercise (RDC2)

1.12.2 DC2 Controller

To set the exerciser on the DC2 controller, first press

AUTO to place the controller into automatic (standby)

mode. Then press and hold the Exercise button. The

generator set will start and run a 20-minute unloaded

cycle exercise. The generator set will run automatically

for 20 minutes at the same time every 7 days. See the

generator set Operation Manual for more information.

1.12.3 Loaded Exercise

In order to set a loaded exercise using the RDC2 or DC2

controller, a Kohlerr Model RXT transfer switch must be

connected. See the generator set operation manual for

instructions to set a loaded exercise.

To set a loaded exercise on a generator set connected to

a transfer switch other than a Model RXT, use the

transfer switch controller to set the exercise. Refer to

the transfer switch operation manual for instructions.

Setting will flash.

Press the up and down arrow

buttons to change the setting.

Press Select to save the

setting.

tp6803

TP-6803 12/11