Kohler 15EORZDB Operasi - Halaman 16

Jelajahi secara online atau unduh pdf Operasi untuk Generator Portabel Kohler 15EORZDB. Kohler 15EORZDB 48 halaman. Commercial/recreational mobile generator sets

Halaman Cetak

2.5.4

Power Modes

The ADC 2100 controller's communication parameter

can be set for three different power modes:

Note: Consult an authorized Kohler dealer/distributor

for parameter adjustments.

Continuous power mode.

powered continuously to allow communication with the

remote gauge at all times. In this configuration, use the

remote gauge for remote start and stop as well as

generator set monitoring.

recommended to maintain the battery.

Note: The controller is powered by the generator set

engine starting battery. Remote communications

require an active (powered-up) controller. Be

advised that the ADC consumes 250 mA when the

master switch is in the AUTO position. If you do

not plan to use your generator set for a long period

of time, Kohler recommends moving the master

switch to the OFF/RESET position (0 mA draw).

One-hour power down mode.

powers down after 1 hour of inactivity. In this mode,

use a remote start/stop switch or the generator set

master switch to activate the controller after it has

powered down. The remote gauge is powered during

generator set crank and run only.

configuration, the drain on the battery is reduced but

the remote gauge cannot be used for remote

start/stop.

Install a separate start/stop switch if

remote start/stop capability is required.

48-hour power down mode. If the ADC 2100 is not

configured for a CAN gauge, the controller will power

down after 48 hours of inactivity. If the generator set

has been started, the controller will power down

48 hours after the generator set stops.

Section 2 Operation

The ADC 2100 is

A battery charger is

The ADC 2100

In this

2.5.5

Fault Shutdowns

The generator set shuts down automatically under the

fault conditions listed in Figure 2-5 and the controller

displays a fault code. The generator set cannot be

restarted until the fault condition is corrected and the

controller is reset.

See Section 2.5.6 to reset the

controller after a fault shutdown. The controller resets

automatically after a battery voltage fault condition is

corrected.

Shutdown switches on the generator set automatically

reset when the problem is corrected. The high engine

temperature switch automatically resets when the

generator set cools. However, the fault does not clear

until the controller is reset.

The controller displays a fault code but the generator set

does not shut down under the conditions shown in

Figure 2-6.

TP-6551 2/14