Kohler 15REYG Operasi - Halaman 28

Jelajahi secara online atau unduh pdf Operasi untuk Generator Portabel Kohler 15REYG. Kohler 15REYG 40 halaman. Commercial generator sets

Halaman Cetak

7. Use a gapping tool to gently bend side electrode

closer to or farther from the center electrode to set

the correct gap. See Figure 3-10. Position the side

electrode directly over the center electrode.

Figure 3-10 Spark Plug Gap Adjustment

8. Reinstall the spark plug.

electrode against the cylinder head. Rotate the

spark plug clockwise until you feel resistance.

9. Use a torque wrench to torque each spark plug to

25 Nm (18 ft. lbs.). Otherwise, hand-tighten the

spark plug until you feel resistance.

10. Use a ratchet wrench to final tighten an additional

1/4 turn. Do not overtighten, as doing so may strip

the threads or alter the electrode gap setting.

11. Check the spark plug wire connector in the boot for

accumulated dirt, grease, and other debris, and

clean as necessary.

12. Firmly push spark plug boot onto the spark plug.

Section 3 Scheduled Maintenance

1-511

Do not bump the

3.8 Battery

Consult

the

battery

regarding battery care and maintenance.

WARNING

Sulfuric acid in batteries.

Can cause severe injury or death.

Wear

protective

clothing.

Battery acid may cause

blindness and burn skin.

Battery electrolyte is a diluted sulfuric acid. Battery acid

can cause severe injury or death. Battery acid can cause

blindness and burn skin. Always wear splashproof safety

goggles, rubber gloves, and boots when servicing the battery.

Do not open a sealed battery or mutilate the battery case. If

battery acid splashes in the eyes or on the skin, immediately

flush the affected area for 15 minutes with large quantities of

clean water. Seek immediate medical aid in the case of eye

contact. Never add acid to a battery after placing the battery in

service, as this may result in hazardous spattering of battery

acid.

Battery acid cleanup. Battery acid can cause severe

injury or death. Battery acid is electrically conductive and

corrosive. Add 500 g (1 lb.) of bicarbonate of soda (baking

soda) to a container with 4 L (1 gal.) of water and mix the

neutralizing solution. Pour the neutralizing solution on the

spilled battery acid and continue to add the neutralizing

solution to the spilled battery acid until all evidence of a

chemical reaction (foaming) has ceased. Flush the resulting

liquid with water and dry the area.

Battery gases. Explosion can cause severe injury or

death. Battery gases can cause an explosion. Do not smoke

or permit flames or sparks to occur near a battery at any time,

particularly when it is charging. Do not dispose of a battery in a

fire.

To prevent burns and sparks that could cause an

explosion, avoid touching the battery terminals with tools or

other metal objects. Remove all jewelry before servicing the

equipment. Discharge static electricity from your body before

touching batteries by first touching a grounded metal surface

away from the battery. To avoid sparks, do not disturb the

battery charger connections while the battery is charging.

Always turn the battery charger off before disconnecting the

battery connections. Ventilate the compartments containing

batteries to prevent accumulation of explosive gases.

manufacturer's

instructions

goggles

and

TP-6728 10/11