A-Tach Mounts 50066 Manual

Jelajahi secara online atau unduh pdf Manual untuk Aksesori Mobil A-Tach Mounts 50066. A-Tach Mounts 50066 2 halaman.

A-Tach # 50066

Designed for: Lexus UX 2019-20__

For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE

attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the

mount will appear to be a little too big or small for the intended location. The vehicle mount must be

installed BEFORE a device holder is screwed onto the vehicle mount.

Once screwed together the products are considered used and non-refundable.

The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.

Once it is attached, it should remain attached until you would like to permanently remove it.

WARNING:

AVOID extreme heat conditions. It can damage the device and the mount.

(1)

Clean the area where the mount will attach.

The lower edge of the mount will attach into the

seam illustrated with the arrow in the photo.

(3) Insert the thin edge of the seam tool into the

lower seam to open the seam a little.

See additional instructions on the back side.

ST-1

NOTICE: A-Tach Mounts will not be responsible for

any damage to the vehicle due to the installation

and/or use of the product. The product has been

tested to fit securely to the listed vehicles.

Instructions are provided for your convenience.

You are responsible for the use of the product and

to determine if you have the skill to attach the

product without causing damage to your vehicle or

the product.

Read all instructions and view the photos before

attaching this product.

(2) The top edge of the mount will attach into the

seam just behind the top vent frame illustrated

with the arrow in the above photo.

(4) Remove the covering from the tape. Insert the

lower edge of the mount into the seam next to the

seam tool.

A-Tach

Mounts