AQC MAXIREACH EBD-61505 Panduan Pemilik - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Industri AQC MAXIREACH EBD-61505. AQC MAXIREACH EBD-61505 16 halaman. Pivoting extension boom

Halaman Cetak

Pivoting Extension Boom

10 . Insert tie rod end section of pull rod into boom base

pull rod support bracket and attach with fastener.

Replace last nut and washer onto threaded end of

pull rod.

Note: At this point, do not try to adjust and level the

horizontal support beam. Wait until optional equipment at

end of swing boom has been installed.

11 . Using the hose clamps supplied, fasten flexible hose

from spiral pipe section to boom base flexible hose

flange.

9.2.2

Assembly (middle pivot, if ordered)

1. Remove friction disks and fasteners from horizontal

steel tube middle pivot bracket.

2. Slide middle pivot assembly into pivot bracket.

3. Insert (1) friction disk (#10) over and under the pivot

section.

4. Using a spike, align holes of friction disks to pivot

assembly, ready for fasteners insertion.

5 . Insert bolt and washer from the top of assembly

and attach with nut and washer underneath pivot

assembly.

6. Using the hose clamps supplied, fasten flexible hose

from spiral pipe section to middle section.

9.3

Connection of boom base to exhaust

ductwork

MAXIREACH extension swing booms are supplied with

one (1) duct companion flange. By factory standards,

companion flange is installed on the upper (top) part of the

boom base. Field modification to have companion flange

installed at the bottom is as follows;

1. Remove duct companion flange from upper boom

base section

2. Remove boom base cover plate from lower boom

base section

3. Install duct companion flange on lower boom base

section

4. Install boom base cover plate on upper part of boom

base.