AQC MAXIPLY DMP-170S Panduan Pemilik - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pengumpul Debu AQC MAXIPLY DMP-170S. AQC MAXIPLY DMP-170S 20 halaman. Open type dust collector

Halaman Cetak

TROUBLESHOOTING

Problem

Smoke or dust

escaping from the

filter or around

the filter frame

Drop in filter

efficiency

Probable cause

Filter envelope not

installed properly

Leak in filter envelope

Damaged seal

High level of humidity

within the collector

Air volume too

low or too high

Filter envelope not

suited for dust to be

filtered

Filtered air tempe-

rature is higher than

normal

Static electricity build

up in dust collector

Multiple pocket type dust collector

Solution

Tighten fasteners on filter frame to ensure proper seal.

Repair or replace filter envelope.

Repair or replace seal.

Check humidity level or relative humidity within the col-

lector. A slightly higher humidity level may be corrected

by closing some gates and by shaking the filter. If the

humidity level is too high, take necessary measures to

dry the the air before it enters the collector.

Check for speed and motor rotation and the position of

gates. Make necessary adjustments to obtain original

specifications.

Replace filter envelope with a filtration system suited for

the dust to be filtered.

Check temperature of air to be filtered. Bring necessary

adjustments to obtain satisfactory temperature.

Check for appropriate grounding wires of collector, com-

ponents and ducting system. Increase relative humidity

of air to be filtered if lower than 50% R.H. until the dust

to be filtered is affected.