AQC MAXIVIBE AMV-450 Panduan Pemilik - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pengumpul Debu AQC MAXIVIBE AMV-450. AQC MAXIVIBE AMV-450 20 halaman.

5. Lift the collector cabinet using the eye bolts. Position above the dust storage compartment

making sure to align the hole pattern of the cabinet with the dust storage compartment hole

pattern. Align temporarily into place using tapered steel pins.

6. Gently lower the cabinet onto the dust storage compartment and keep the hole patterns

aligned.

7 . Tightly bolt the two (2) sections together using the nuts, bolts and washers. Collector has to

be airtight.

8.21

Multiple cabinet version:

8. Collectors with double or triple cabinets, the installation of the acoustical enclosure and

fan/motor assembly will be required. Lift the fan/motor assembly and position above the

collector while aligning the fan inlet with the collector opening. Fasten the fan using the nuts,

bolts and washers.

9. Locate the pre-installed fasteners that will be used to join the roof and acoustical enclosure

around the roof of the collector and remove them.

10 . Lift the acoustical enclosure and position above the collector cabinet. Align the acoustical hole

pattern with collector cabinet hole pattern using tapered steel pins. Attach both components

together using the fasteners.

11 . Proceed with electrical connection.

5. Lift the ﬁlter cabinet using the lift lugs. Using spikes, position th

WARNING!

The use of a swing jib is recommended in order to avoid

damages to the collector cabinet.

6. Lower the ﬁlter cabinet onto the dust storage section and align

7. Attach the ﬁlter cabinet to the dust storage section using the su

Figure 3

Drawing # 3

Apply two strips of butyl adhesive on the dust storage se

outline. One strip should be applied inward of the bolt h

strip outward of the bolt holes (Figure 4).

above the dust storage section making sure to align the cabinet

with the dust storage bolt holes.

WARNING

The use of a spreader is recommended to avoid

damages to the ﬁlter cabinet.

washers and bolts. Tighten bolts for an adequate seal.

Support

Cross braces

Shaker type dust collector

plates

Unside bag

removal

legs

MAXITUBE