Aqua Computer 34109 Panduan Memulai Cepat - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Komputer Aqua Computer 34109. Aqua Computer 34109 8 halaman.
aqua
computer
2. 2. 2. 2. Scope of delivery
Scope of delivery
Scope of delivery
Scope of delivery
One reservoir
●
Mounting material
●
This manual
●
3. 3. 3. 3. Assembly instructions
Assembly instructions
Assembly instructions
Assembly instructions
3.1.
3.1. Installation of a D5 pump motor
3.1.
3.1.
Installation of a D5 pump motor
Installation of a D5 pump motor
Installation of a D5 pump motor
Skip this section if a pump is already installed into the reservoir.
If you have a complete D5 pump instead of a D5 pump motor, you will have to
disassemble the pump first. The only parts needed are the housing with electronic
components and the impeller.
Install the pump motor as follows:
1. Place the gasket into the ULTITUBE base part.
2. Place the ULTITUBE base part on top of the D5 pump motor.
3. D5 NEXT only: Remove the controller unit from the pump
4. Slide the mounting ring onto the rear side of the pump motor and fasten the
ring by screwing it onto the ULTITUBE base part.
5. D5 NEXT only: Re-attach the controller unit to the pump.
3.2. Installation into a PC case
3.2.
3.2.
3.2.
Installation into a PC case
Installation into a PC case
Installation into a PC case
Mounting material for upright standing installation (for example to the bottom of
the case) or lateral installation (for example to a side panel of the case) is included
in delivery. A standing installation should be preferred for stability reasons.
If the reservoir is used in combination with a D5 NEXT pump, the reservoir can be
installed standing directly on the pump. Additional stabilization is recommended, a
suitable mounting bracket is available (product code 34111, included in reservoir
variants 34100, 34109 and 34110 only).
For additional, vibration dampening fixation in the upper area of the glass tube, a
rubber fixation ring is available. The rubber ring can be slipped over the top of the
reservoir onto the glass tube (product code 34114, included in ULTITUBE D5 PRO
only).
Furthermore, mounting brackets for installation to standard 120 mm or 140 mm
fan mounting positions are available as accessories (product codes 34112 and
34113, not included in delivery.
© 2020
Aqua Computer GmbH & Co. KG
Gelliehäuser Str. 1, 37130 Gleichen
ULTITUBE D5
- 3 -