A.B.S. Flexilo MINI Petunjuk Perakitan, Pengoperasian, dan Pengisian - Halaman 9

Jelajahi secara online atau unduh pdf Petunjuk Perakitan, Pengoperasian, dan Pengisian untuk Peralatan Industri A.B.S. Flexilo MINI. A.B.S. Flexilo MINI 19 halaman. For wood pellets. construction: plug-in system galvanized

Halaman Cetak

Operating and Assembly Instructions – A.B.S. Flexilo MINI for wood pellets

Room Layout

3 Room Layout

Please observe the following planning steps; only in this way can

problem-free operation be assured.

Failure to comply can result in damage to the equipment and system

malfunctions or put individuals and equipment at risk.

Planning the room layout is a prerequisite and requirement for setting up the A.B.S. Flexilo

for wood pellets. The plans for the rooms must have already been given some thought when

ordering the silo. Nevertheless, prior to installation, check the dimensions and existing

conditions (see the next chapter).

Compliance with local regulations and proper construction of the building are the

responsibility solely of the purchaser of the equipment and are prerequisites for coverage by

the warranty and guarantee.

3.1 Room size

The required silo size depends on the size of the room. Please check the dimensions of both

the silo and the room prior to installation. The dimensions of the silo frame are stated on the

delivery documents.

The dimensions of the silo frame can be determined by measuring the steel parts:

Length of the frame = 980 mm

Width of the frame = 980 mm

Height of the frame = 1.220 mm

The silo and the removal units must be easily accessible for maintenance.

3.1.1 Distance from walls

A distance of 10 to 15 cm is required between the silo frame and walls in order to provide

ventilation at the back of the silo and protect against mechanical damage. Because of the

bulk nature of the pellets, the side walls of the silo may bulge slightly.

For the filling with pellet bags and the maintenance should be one side of the silo completely

accessible.

3.1.2 Distance from ceiling

A minimum distance of 20 cm is required between the upper edge of the silo frame and the

ceiling to provide space for the filling line. To prevent damaging the top fabric of the silo

during filling, no sharp or sharp-edge objects should be fastened to the ceiling.

In order that the filling with pellet bags is possible, see that it is enough distance between

frame edge and ceiling.

Subject to technical change

Issue 09/2016

Page 9 of 19