AAVIX GC-1032 Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Detektor Logam AAVIX GC-1032. AAVIX GC-1032 15 halaman.

1. VOLUME/POWER switch

Rotate the VOLUNE switch clockwise away from OFF to power on

the detector. Rotate it fully counter-clockwise to power off the

detector. To increase the volume level, rotate the switch clockwise.

2. PHONE jack: You can insert the headphones' plug of 3.5mm into

the PHONE jack and operate without trouble. At this time the

internal speaker is disconnected.

3. LCD DISPLAY

DISC numeric indicator Low BATT indicator

SENS: Press SENS then + or – to increase or decrease the

sensitivity. LCD will display the current setting of sensitivity. If the

target depth is beyond the max. sensitivity of the detector, the

target will not be found.

DISC numeric range(0-80): Press DISC then + or – to select the

desired DISC number. If the target material is beyond the DISC

range, it can't be discriminated.

Note: The highest DISC numeric setting is 80. If you set the

DISC number to 80, all targets less than this number will not be

detected.

NOTCH: Press NOTCH, then + or – to select the target to be

notched. The cursor above the selected target will flash. Press

NOTCH again, the target name below the cursor will disappear.

Target indicator

DISC / NOTCH

indicator

SENS/DEPTH

indicator

Target numeric indicator