AAVIX AGT3420 Panduan Pemilik - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peniup Salju AAVIX AGT3420. AAVIX AGT3420 20 halaman. 20 inch 15amp snow thrower

Halaman Cetak

Chute Deflector Adjustment

1. Loosen the locking knob and adjust

the chute deflector to a suitable height.

The machine offers different positions

(0~60°). Re-tighten the locking knob.

(Fig.9).

WARNING! Ensure switch off the

motor first, then disconnect the plug

from the power supply, before

adjusting the discharge chute.

Operation

NOTE: Before using this machine,

make sure that the power source you

will use compiles with the

specifications detailed in this manual.

Before inserting the plug into the

socket, verify that the snow thrower's

auger and rubber plates are firmly

secured, and that the rubber plates are

facing the correct direction. Perform a

test run to ensure that the rotor turns

freely.

Before connecting the snow thrower

with the electric power supply, make

sure that the mains supply voltage is

120V.

Securing the Extension Cord

To prevent the appliance cord from

disconnecting from the extension cord

during operation, make a knot with

the two cords as shown. (Fig.10)

Powering ON/OFF

Fig.9

rotating immediately after the snow

thrower is switched on. Keep hands

and feet away from the auger.

1. Press the safety push-button.

2. Squeeze the switch bar. (Fig.11)

Fig.11

3. Once the snow thrower starts,

release the safety push-button and

proceed with operation.

4. To power OFF, release the switch

bar.

machine and disconnect the plug from

the power supply when transporting

WARNING! The auger starts

WARNING! Lift the front of the

Fig.10