Dexter Laundry 400 EXPRESS Buklet Pemilik - Halaman 11
Jelajahi secara online atau unduh pdf Buklet Pemilik untuk Mesin cuci Dexter Laundry 400 EXPRESS. Dexter Laundry 400 EXPRESS 13 halaman. 25lb capacity computer control coin-op washer installation & operation instructions
Halaman CetakThe selected bath LED begins to blink. The display shows the letters "ct" in the left two digits
and the bath cycle time in the right two digits. Again the up/down buttons change this value.
The range is shown below. If zero time is entered, then the bath will be skipped and the program
will return to the bath selection. When the desired cycle time is selected, push enter.
The display shows the letter "t" in the left digit and the letters "CC" appear in the right two
digits. This is the bath water temperature. The selection choices are shown below but for the
coin washer the value is defaulted to CC. As it is not selectable with a coin washer, the owner
pushes enter to continue.
The display shows the letter "L" in the left digit and the letters "LO" appear in the right two
digits. This is the bath water level. The selection choices are shown below but for the coin
washer the value is defaulted to LO. As it is not selectable with a coin washer, the owner pushes
enter to continue.
The display shows the letters "dF" in the left two digits and the letter "t" appears in the right
digit. This is the bath delay fill. The selections are "t" for counting down bath time during the
fill or "d" for delay the bath time until water level is reached. When the desired selection is
made, push enter.
The display shows the letter "S" in the left digit and the bath spin time in the right two digits.
Again the up/down buttons change this value. The range is shown below. When the desired spin
time is selected, push enter.
The display shows the letters "IS" in the left two digits and the injection selection appear in the
right digit. For the coin washer the default value is "0" and cannot be changed. Push enter.
At this point the bath LED stops blinking. The display will show "b" and the next bath LED
lights. Again use the up/down buttons to change the bath selection. The program will only exit
when one of the bath lights is NOT blinking. To exit the programming mode, push exit. The
cycle will be stored when exiting the programming mode.
COIN WASHER CYCLE PARAMETER RANGES
The range of each cycle parameter is shown below:
Cycle Time "ct"
Water Temperature "t"
Water Level "L"
0 to 15 minutes for Prewash, Rinse1 and Rinse2
3 to 15 minutes for Wash and Final Rinse
For the bathes that can, if the time is set to zero, then the bath will
be eliminated from the cycle.
HH – hot, CH – warm, CC – cold, EE – no water
The owner can set the bath default. For the wash bath, the
customer overrides the default for that cycle when the
temperature is selected.
LO – low
The owner can change the displayed value, but for a coin
washer only LO will be put into the cycle.