Aqua Creek F-004PPPB-AT1 Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Sistem Pengangkatan Aqua Creek F-004PPPB-AT1. Aqua Creek F-004PPPB-AT1 20 halaman.

Halaman Cetak

24V BATTERY SYSTEM OPERATING AND

INSTALLATION INSTRUCTIONS

WALL MOUNT CHARGER

CONTROL BOX

& HANDSET REMOTE

24 V SEALED BATTERY

The Pro Pool Lift

Battery system comes with a 24v sealed rechargeable battery, wall

mount charging unit (with mounting bracket), control box, and a waterproof handheld

controller. The control box is mounted to the Pro Pool Lift

has a plug-in socket for

and

both the actuator and the handheld controller. The battery mounts directly above the

control box with a quick-release clip.

To operate the Pro Pool Lift

, plug in the handheld controller to the control box and

push the corresponding button to either lower or raise the unit. The lift should be able to

complete approximately 10-20 full cycles before the low battery indicator tone will

sound. The low battery tone indicates that there is approximately 20% battery life

remaining. At this point, DO NOT ATTEMPT TO OPERATE THE LIFT, remove the

battery from the unit and recharge on the wall mounted charging unit.

To recharge the battery, simply grip the top of the battery and depress the clip on the back

of the battery. This will unclip the battery from the control box bracket and the battery

can then be clipped into the wall mount charger. When the charger is plugged in the

green ON light will illuminate. When the battery is correctly mounted to the charger, the

orange CHARGE light will illuminate. When the battery is fully charged, the

CHARGE light will GO OFF and the battery is ready for use.

WHEN THE BATTERY IS NOT BEING USED IT SHOULD BE STORED ON

THE CHARGER AND NEVER ON THE LIFT. DO NOT LEAVE THE BATTERY

ON THE LIFT WHEN THE LIFT IS NOT IN USE.