Aqua Creek Products PRO POOL LIFT F-004PLB-R Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Sistem Pengangkatan Aqua Creek Products PRO POOL LIFT F-004PLB-R. Aqua Creek Products PRO POOL LIFT F-004PLB-R 17 halaman. 450 lb. (204kg) maximum capacity

Halaman Cetak

PRO POOL LIFT

ITEM #

QTY.

TOOLS NEEDED:

ASSEMBLY INSTRUCTIONS

1. Begin by locating all parts in the above parts list.

2. Attach the headrest pad to the support bar by slipping the

cross bar into the sewn supports on the back of the headrest

pad.

Adjust the height of the headrest for the user and mark the

hole locations (FIGURE 8).

Drill a 5/64 inch [2 mm] hole at the marked locations from

step 3.

5. Install the headrest with the supplied stainless steel screws

(FIGURE 8).

SAFETY & MAINTENANCE INSTRUCTIONS

Do not play on or around this lift

1. Check the PRO POOL LIFT

and that all hardware is properly tightened. If there are any worn parts, replace

them BEFORE using the Pro Pool Lift

888-687-3552 to order any parts.

2. Aqua Creek Products, LLC lifts shall be grounded per local codes.

3. At least ONCE A WEEK, the Pro Pool Lift

Do not spray the Pro Pool Lift

Wipe all surfaces clean with a damp, non-abrasive cloth. When cleaning the Pro

Pool Lift

, use non-abrasive soap and water. Avoid harsh chemicals and

disinfectants.

4. Always read the label instructions on any cleaner carefully before applying it to a

surface.

5. The WARNING & INTENDED USE labels on the Pro Pool Lift

maintained in readable fashion. If they become un readable or faded, please

replace the label immediately. Replacement labels are available from AQUA

CREEK PRODUCTS LLC. 1-888-687-3552.

Compliments of www.poolsandstuff.com

– HEADREST

(OPTIONAL)

HEADREST SUPPORT

1/8" x 3/4" S.S. SCREW

5/64" DRILL BIT

PHILLIPS SCREWDRIVER

before each use to assure there are no worn parts

. You can call our customer service at 1-

must be cleaned with fresh water.

24v battery unit directly with any pressure.

DESCRIPTION

HEADREST PAD

need to be

FIGURE 8