Aqua Creek Products Scout 2 Manual - Halaman 9

Jelajahi secara online atau unduh pdf Manual untuk Sistem Pengangkatan Aqua Creek Products Scout 2. Aqua Creek Products Scout 2 16 halaman. Lift graph
Juga untuk Aqua Creek Products Scout 2: Manual (2 halaman)

Scout 2 Assembly Instructions (cont.)
6.
The CHAIR ASSEMBLY will arrive attached to the CHAIR ARM adjusted to its highest position.
To adjust the CHAIR ASSEMBLY to a lower position remove the hardware as shown in FIGURE G.
Slide the SEAT ASSEMBLY to its desired position (in 4" increments) and reinstall the hardware. The
maximum adjustment is 16".
DO NOT ATTACH THE CHAIR ASSEMBLY ANY LOWER THAN THE BOTTOM TWO HOLES – ALWAYS USE
THE TWO (2) SUPPLIED HEX BOLTS TO ATTACH THE CHAIR ASSEMBLY TO THE CHAIR ARM!
NOTE: For most applications the seat will be installed in its lowest position. For applications where a
wall or curb must be cleared the seat should be installed in a higher position. In its highest position,
the seat will clear a 11" [279mm] high wall with a footrest and a 26" [660mm] high wall with a legrest.
CHAIR ARM
ADJUSTMENT
HOLES IN 4"
INCREMENTS
(16" ADJ. RANGE)
CHAIR ADJUSTED
TO LOWEST
POSITION
Copyright © 2017 Aqua Creek Products All Rights Reserved
3/8" X 2-1/2"
3/8" FLAT
HEX BOLT
WASHER
5/16" X 3-1/2"
HEX BOLT
5/16" FLAT
WASHER
3/8" FLAT
WASHER
3/8" NYLOCK
NUT
5/16" NYLOCK
NUT
5/16" FLAT
WASHER
FIGURE G
9
Revised 5/9/17