Aqua Creek Products F-RNGR2-05 Manual - Halaman 9

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Pencahayaan Aqua Creek Products F-RNGR2-05. Aqua Creek Products F-RNGR2-05 20 halaman. Pool lift

Halaman Cetak

1. Attach seat belt to the seat.

2. Install the Ranger 2 pool lift onto the four (4) anchors using

the supplied 1/2 inch x 1 1/2 inches stainless steel hex head

bolts and 1/2 inch stainless steel washers. Make sure all bolts

are tight before using the lift.

3. Apply dielectric grease to the plug terminals, including

the o-ring seal. Plug the handset cable into the large handset

socket on the bottom of the control box. Press the cord end

fi rmly into the socket until you are sure it is completely in the

socket. Failure to fully push the remote cord into the socket may result in faulty or interrupted

operation.

4. Before installing the battery, place it on the charging unit and let it charge for 24 hours. Make

sure the orange "charge" light illuminates when the battery is being charged. When the orange

charge light shuts oﬀ , the battery is fully charged.

5. Remove the fully charged battery

from the charger and install it on top

of the control box. The battery will line

up with the control box, and will 'click'

when it properly locks in place.

6. With the lift completely assembled,

run the lift fully out and back in 3-5

times, without weight, for the lifts

"break in" cycle period.

WHEN NOT IN USE, STORE THE

BATTERY ON THE CHARGER!

Ranger 2 Assembly Instructions

SEE FIGURE D

RANGER 2 POOL LIFT

ATTACH FULLY

CHARGED BATTERY

CONTROL BOX

1/2" TOOTH

WASHER (1)

ANCHORS (4)

INSTALLED

FLUSH W/ DECK

LOOP ON TOP

FOR EASY ACCESS

THREAD THROUGH

SLOTS AND PINCH

FIGURE D

TOGETHER TO HOLD

HANDSET

PLUGS INTO

CONTROL BOX

Revised 5/28/21

1/2" X 1 1/2"

HEX BOLT (4)

1/2" FLAT

WASHER (3)

POOL

WALL