AVM INSPIRATION CS 2.2 Panduan Petunjuk Pengoperasian - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Penguat AVM INSPIRATION CS 2.2. AVM INSPIRATION CS 2.2 20 halaman. Compact streaming cd-receiver

Halaman Cetak

3.11 set balance

Set the balance between right and left channel for optimal stereo image.

3.12 personal setup

Several settings can be done in the personal setup.

To access the personal setup switch the unit to standby (power button (1)). Then press and hold the

most right key under the display (8). While holding that key switch the unit on (power button (2)). The

display now will show "**personal setup***". Release the button (8) and the unit is in personal setup

mode.

When the personal setup is active you can select the desired function using the buttons ! ITEM" (4,

5). The button SELECT (8) activates the function. The setting is done using the buttons ! VALUE" (7,

8). BACK (6) leads you back to other settings. EXIT (6) exits the personal setup and stores the settings.

3.13 set display brightness

Sets display brightness 25% to 100%.

NOTE: The setting 100% can lead to "burn in" effects on the display if the unit is operated in this

setting for a very long time. So please switch the unit to stand by, if not in use.

3.14 bass & treble control

Choose if you want to change bass and treble settings simultaneously for all inputs ("global") or

especially for the actual input ("individual").

3.15 skip unused inputs

Deactivate unused inputs ("SKIP"). The unit will then skip these inputs when the source selector (12) is

pressed or if you select the inputs via the RC 9 remote control.

3.16 define input names

You can individually set the names (max. 8 characters) of the different sources shown in the display (3).

Proceed as follows:

Press SELECT. The display shows now on the left side the old name, on the right side the new name.

The character to change is marked by an underscore. The keys ! ITEM" (4, 5) select the input, the

keys ! POS" (7, 8) select the position of the character to change. The marked character can be set

using the volume knob (14). When you are ready, simply press BACK (6). and the new names will be

stored.

3.17 gain fix / variable

In a surround system the channel balance, tone setting and bass management are done by the

decoder. This setting must not be altered by another component because the channel balance the

would be incorrect. For this application the CS 2.2 offers the fixed gain function (only for inputs 1-3).