AVM EVOLUTION CD 5.2 Panduan Petunjuk Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pemutar CD AVM EVOLUTION CD 5.2. AVM EVOLUTION CD 5.2 14 halaman.
Juga untuk AVM EVOLUTION CD 5.2: Panduan Petunjuk Pengoperasian (14 halaman)

Halaman Cetak

2 Basic operation

2.1 First operation / self test

In case your CD player was not connected to mains a self test will be performed when it is switched on

by the mains switch (29) for the first time. The unit will check its configuration and that all the installed

components work properly. The procedure is shown in the display. Afterwards the unit will switch to

stand-by.

2.2 Switching on / stand-by

Using the button power (1) you can switch between on (operate) and stand-by. In the on state the

display (8) lights up and the LED (7) is off. In stand-by mode the display is off and the LED is on to

indicate that the unit is still connected to mains.

CAUTION: When switched to stand-by the unit is still connected to the mains. In case of a

thunderstorm or if you leave the house for a longer time we recommend that you switch the amplifier

off by using the mains switch (29) or pull the mains plug (28).

2.3 Display

When the unit is switched on, the display shows information about the current settings and state of

your CD player. Apart from informations about the operating status (CD player, Digital Input etc.) the

lower line shows you currently active settings of the D/A converter: On the left-hand side the sample

rate is displayed. On the right-hand side you will find the current filter setting ("Smooth" or "Steep").

VOL / FIX

Depending on your selection of a fixed or variable output level of the analogue outputs of your CD 3.2 /

CD 5.2 (see 3.1.1), an information on the current output level state is displayed in the upper-middle

part of the display (8). VOL indicates a variable level setting enabling you to control the output level of

the analogue outputs (16-18) by pressing the VOLUME buttons on your RC 3 remote control. FIX

indicates a fixed output level setting.

2.3.1 Display in CD player mode

At the centre of the display the total duration of an inserted CD is displayed, while stopped (STOP). As

soon as the CD is played (PLAY) or paused (PAUSE), the time already elapsed of the current track is

displayed.

TRACK

On the left-hand side both the current title is displayed (big figures) and the total number of available

tracks of the inserted CD (small figures).

STATUS

On the right-hand side the current operating status is displayed (STOP, PLAY, PAUSE).

PROG

In case of a currently active track programming both the currently playing track and the total number of

programmed tracks is displayed on the left-hand side (for example "PROG 2/17").

RND

In case of an active random play the currently playing track and the total number of programmed

tracks of the random play is displayed on the left-hand side (for example "RND 5/12").