AvMap GeoPilot II Panduan Cepat - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Cepat untuk GPS AvMap GeoPilot II. AvMap GeoPilot II 13 halaman. Avmap geopilot ii: quick start

This sub-menu contains the various options that define how the Geopilot2 displays

units of measurement

Date & Time Setup

These functions control how the Geopilot2 displays time and date settings.

Deletes all Flight Plans, Track history and User Waypoints.

You can delete all stored Projected Radial lines displayed on the Moving Map with this

one function.

Factory Defaults

This will restore the GeoPilot2 to all factory default settings.

1.3 TURNING THE GeoPilot2 ON/OFF

Before powering On the GeoPilot2, check for the correct voltage (10-35 Volt DC).

1.3.1 TURNING ON

Press and hold 'NEAR' for 1 second. The GeoPilot2 emits one rapid beep sound

and a Title page containing information about the Product name, Software version,

library version and cartridges installed is displayed. This data can also be viewed in

the "About" page in the "Main Menu".

After a few seconds the Warning page is displayed, reminding you that the GeoPilot2

is an aid to navigation and should be used with appropriate prudence. The electronic

charts are not intended to substitute for the official charts. Press 'ENTER' to open the

Moving Map screen.

'NEAR' 3 sec.: a countdown timer appears on the screen, if you release the key

before the countdown timer reaches zero, the GeoPilot2 will remain On.

Press and hold 1 sec 'NEAR' to adjust the brightness of the display and keyboard (do

not press and hold the key for 3 sec. or the "power-off " message will be displayed!).