AvMap Farmnavigator 1MINUTE RTK Panduan Cepat - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Cepat untuk Penerima AvMap Farmnavigator 1MINUTE RTK. AvMap Farmnavigator 1MINUTE RTK 2 halaman. Universal gnss receiver
Juga untuk AvMap Farmnavigator 1MINUTE RTK: Panduan Instalasi (8 halaman)
Halaman Cetak
2. How to properly install 1MINUTE RTK on the tractor
The 1MINUTE RTK antenna embeds a fully featured inertial platform able to provide accurate
dynamic vehicle information and precise terrain compensation. In order to achieve the highest
accuracy, the antenna must be installed following the instructions below:
1. On the roof of the tractor, horizontally,
2. In the center of the cabin.
on a flat and stable support to avoid
vibrations
3. How to use 1MINUTE RTK with G7 Farmnavigator
Connect the power cable to the G7 Farmnavigator's GPS Antenna connector and you are ready
to use your 1MINUTE RTK.
Follow the instructions available in the G7 Farmnavigator's user manual in order to check the
satellite signal on your G7 Farmnavigator.
3.1 G7 Farmnavigator series Connection scheme
Generic Device
Controller
GPS Antenna
Images are for illustrative purposes only and can differ from the real product.
3. The connector for power cable
must be oriented opposite to the
driving direction.
1MINUTE RTK
Power cable
4. How to use 1MINUTE RTK with third-party devices
1MINUTE RTK can be used as a high precision GNSS receiver for any third-party device
compatible with serial communication and NMEA 0183 messaging (RS232 protocol).
4.1 Third-party devices connection scheme
To connect 1MINUTE RTK to a third-party device, simply connect your device to the DB9
connector end of the power cable according to the Pin-Out presented below.
PIN n°
2
3
4
5
4.2 NMEA Baud rate
1MINUTE RTK can output standard NMEA messages at different baud rates. The default setting
is at 115200 bps which is the most commonly used by third party displays.
For any other specific setup, please refer to your Distributor/Reseller.
5. Register 1MINUTE RTK
In order to register your 1MINUTE RTK, access Farmnavigator.com/mygarage website and
complete the registration in few simple steps. Once it has been registered successfully, your
1MINUTE RTK starts sharing information with the remote server.
5.1 NTRIP client
The NTRIP Client is the software element used by the receiver to get the RTK correction from
the Internet. Please refer to your Distributor/Reseller for NTRIP client specific setup.
6. List of countries where the connectivity is supported
Andorra, Austria, Belgium, Bulgaria, Cyprus, Croatia, Denmark, Estonia, Finland, France,
Greece, Germany, Hungary, Iceland, Ireland, Italy, Latvia, Liechtenstein, Lithuania, Luxembourg,
Malta, Netherlands, Norway, Poland, Portugal, Czech Republic, Romania, UK, Saint-Marin,
Spain, Slovakia, Slovenia, Sweden, Switzerland, Vatican.
6
1
9
5
Third-party
device
PIN-OUT
Function
GPS TX
GPS RX
GPS VCC
GPS GND