A.J.Antunes 9210822 Manual - Halaman 13

Jelajahi secara online atau unduh pdf Manual untuk Pemanggang roti A.J.Antunes 9210822. A.J.Antunes 9210822 20 halaman. Club toaster

Halaman Cetak

INstallING belt WraPs

Follow this procedure to install new Belt Wraps.

Note: Install belt Wraps with the studs facing the

INsIde of the unit. belt Wraps must be installed

so that the gap of one belt Wrap is located in the

opposite position of the gap on the other belt Wrap

(figure 13).

1. Wipe both sides of the new Belt Wraps with

KaYQuat II™ sanitizer (HCs) and allow to air

dry.

figure 12 Installing belt Wraps

Note: to obtain new belt Wraps, contact the fac-

tory at 1-877-392-7854 (North america only) or 630-

784-1000.

2. Ensure that both lower rollers are locked in the

upper position (Figure 10).

3. Install the front Belt Wrap around the top front

roller with the Connecting Pin towards the bottom

of the unit (Figure 12).

4. Thread the Belt Wrap through the toaster and pull

it around the lower front roller (Figure 12).

Note: Make sure the front belt Wrap is threaded

uNder the support rod. also, make sure that the

belt Wrap studs are facing the INsIde (figure 12).

5. Connect the ends of the Belt Wrap by sliding the

top end over both sides of the Connecting Pin

(Figures 12 and 13).

P/N 1010905 Rev. B 03/12

McDonald's

MaINteNaNCe (continued)

the toP belt Must

be installed under the

support rod.

Connecting

point should

be at this

position

Club ToasTer CTX-200

Note: refer to figure 13 for the proper connection

point locations when installing belt Wraps.

Note: the bottom belt Wrap should be installed

by threading the belt Wrap around the bottom rear

roller, up through the unit, and around the back top

roller. the connecting pin must face the bottom of

the unit. the connection point must match figure

14.

6. Return the lower rollers to full tension by lifting up

and then pulling down on each roller to lock it in

place (Figure 14).

7. Close the Top Cover and Front Cover and reat-

tach the Bun Feeder and Bun Buffer.

8. Press

to resume belt rotation. Place the unit

back into operation.

Lower Belt

Connection

Point

figure 13. Proper belt Wrap Installation

lift both bottom rollers up and

pull down to lock into place. this

tightens belt Wraps.

figure 14. restoring belt Wrap tension

Studs MUST face

inside of Belt Wrap

Upper

Belt

Connection

Point

A.J. Antunes & Co.