A.J.Antunes 9210826 Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Pemanggang roti A.J.Antunes 9210826. A.J.Antunes 9210826 20 halaman. Club toaster

Halaman Cetak

Operating Instructions

Follow these steps to start the Club Toaster:

1. Turn on the Power Switch located at the back of

the unit. There will be a 20-second countdown as

the unit sets defaults.

2. The unit will start to warm up and will show the

Wait

message in the display (Figure 3).

NOTE: The Control Panel and display are located

on the back of the unit.

3. When the unit reaches operating temperature, the

display will read Ready (Figure 4).

4. The unit is ready for operation.

NOTE: If the toasting quality needs to be adjusted,

refer to the section titled "Adjusting Toasting

Quality" in the Operation section of this manual.

PLTN

Wait

PLTN

MOTOR

ADJUST

PRGM

BELTS

STOP/START

Figure 3. Club Toaster Wait Display

PLTN

Ready

PLTN

MOTOR

ADJUST

PRGM

BELTS

STOP/START

Figure 4. Club Toaster Ready Display

P/N 1010993 Rev. H 03/15

McDonald's

OPERATION

SELECT

CLUB TOASTER CTX-200L

Toasting Clubs

Follow these steps to toast clubs with the Club Toaster:

1. Make sure the unit is turned on and that the

Ready

display reads

2. Insert the club into Bun Feeder (Figure 5).

3. The club will emerge from the toaster into the Bun

Buffer.

Figure 5. CTX-200L Toasting Route

NOTE: For all CTX-200 units, the product pass-

through time is 22 seconds (+/- 2 seconds).

Adjusting Toasting Quality

Follow these steps to adjust toasting quality.

1. At the back Control Panel, press and release the

ADJUST button (Figure 6).

2. Use the PREV and NEXT buttons to adjust the

toasting quality to lighter or darker respectively

(Figure 6).

NOTE: Pressing the PREV button decreases toast-

ing darkness. Pressing the NEXT button increases

toasting darkness.

3. Test several clubs to verify that the product is

toasting at the desired quality.

4. If the toasting quality needs further adjustment,

repeat Steps 1 through 3 as necessary.

NOTE: This setting is maintained when the unit is

powered off. The adjustment range is +/- 10% of

cycle time. Therefore, each adjustment represents a

1% change toward the desired result. Two bars on

the display indicate the adjustment is in the center

position.

Large Black Arrows

Club Inside

Indicate Club

Bun Feeder

Route Through

toaster

Bun Buffer