Aqua Flo AQUV-20 Panduan Pemilik - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Penyaringan Air Aqua Flo AQUV-20. Aqua Flo AQUV-20 16 halaman. Ultraviolet disinfection system

Halaman Cetak

Installing the pre-filter

A 5 micron or finer filter must be installed before the UV system. A pre-filter is not included with this system.

Installing the UV unit

1. Screw a mounting clamp to the wall (wall stud) with

base screws as shown in Fig 3 & Fig 3 side view. Use

appropriate wall anchors if not installing on wall stud.

2. Using a level, vertically align the other mounting clamp at

a distance of about 11-12 inches below the first clamp

Mount using base screws (clamp screws should be in

opposite directions).

3. Mount the UV disinfection chamber on the two bases

and holding it with one hand, tighten the mounting

clamps using a screwdriver or appropriate socket wrench.

4. Mount the ballast on the wall slightly above the chamber

with ballast mounting screws (see Fig 3).

5. Install new plumbing using Fig 3 as reference of how the

final installation should look. The inlet/outlet connections

on the UV are MNPT.

6. If you intend to drain the UV during winter to prevent

freezing, install a copper tee at the inlet of the UV

and plumb in a ball valve and a piece of copper pipe

(See Fig 3)

7. Carefully unpack UV lamp and quartz dome. Note: Hold

lamp and dome by the ends with soft, dry gloves or

cloth. Two (2) o-rings come with the dome. The gland

nut O-ring (thinner) fits in the groove of the gland nut.

8. Gently slide the dome O-ring (thicker) over the top (open

end) of the quartz dome to about 1" from the open end,

Fig 4.

9. Gently insert the quartz dome into the gland nut and

gently rotate the dome while pushing in until it

goes past the nut O-ring and touches the inside top end

of the gland nut. See Fig 4 and 5.

Ballast

WATER FLOW

Sediment

Pre-Filter

Drain Port

(Recommended)

Dome O-Ring

Gland Nut

Quartz Dome

TIP: Rotate dome while pushing in

Do not look directly at UV lamp when lanp is on. UV light

can cause serious burns to eyes and skin.

Fig.3

Leave min 36"

clearance on top

Water Sampling

Port

BYPASS VALVE

SIDE VIEW

Quartz Dome

Fig.4

WARNING

12"