AQUA FORTE UltraSieve XL Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Sistem Penyaringan Air AQUA FORTE UltraSieve XL. AQUA FORTE UltraSieve XL 7 halaman.

Halaman Cetak

The auto-adjustable weir with oating devices

The UltraSieve has a oating system to prevent the water in the area under the sieve from rising above the level of the sieve for low speed pumps and also to

prevent the water from going too low to be primed for high speed pumps. The oating device can be installed at 2 di erent levels. You only have to do this once

when installing the UltraSieve or when you change pumps. Procedure: loosen the 10mm bolts in order to move the oating device. Choose one of the 2 levels

and fasten the bolts again. You're done.

Maintenance

It is recommended to monitor the UltraSieve every day. Maintenance is very easy because of the waste outlet. In fact maintenance is about two operations: 1) To

remove the waste that is on the surface of the sieve (every day) en 2) To remove the waste that has gone into the pro le wires of the sieve (only when necessary).

1) Removing the waste that is on the surface of the sieve is very easy by opening the waste outlet and to rinse the waste away with a normal hose pipe. Another

method to have water run over the screen is pushing down the adjustable dam which will ood the screen with water. When the adjustable dam is in a low

position already because of the pump speed you can pull up the dam for a short while and push it back downwards again.

2) To remove the waste that has gone into the pro le wires of the sieve you will need a hose pipe with a powerful spray nozzle or a high-pressure machine. For this

way of cleaning you have to place the sieve in an upright position or take the sieve out of the unit. After a certain period of time the sieve can get "fat" and this will

make it more di cult for the water to go through. You can clean the sieve with i.e. alcohol.

Note: when you use the sieve for the very rst time the surface of the sieve can also be covered with a very thin lm. Make sure you will clean

the sieve very thorough with alcohol before using it.

Technical Speci cations

267,5

SIZE

HOUSING

64 x 72,5 x 75 cm

INLET (3x)

110mm

OUTLET (2x)

90mm

WASTE OUTLET

90/110mm

SIEVE (2x)

450 x 345 mm

CAPACITY

WEIGHT

MATERIAL

1 cm thick Polypropylene

Polypropylene

PVC Slide Valve

Stainless Steel 304

POSITION 1

POSITION 2

725

460

EXTRA INFO

3 x 110 mm inlet

Supplied with 90/63mm ex. tting

Supplied with PVC ring 110mm

300 micron

±40m³/h

± 40 Kg. including sieve elements

Position 1 This level gives the weir its maximum

length, suitable for pump speeds to ± 15m³/h. The

maximum length of the weir prevents the water

level underneath the sieve from going too high for

low speed pumps.

Position 2 This level gives the weir its minimum

length, suitable for pump speeds to ± 40m³/h. The

minimum length of the weir is to have a high water

level under the screen to prevent a high speed pump

from priming air.

640

AquaForte is a trademark of Sibo BV Veghel

PROFESSIONAL

POND

PRODUCTS