Aqua Jet SA 3995 Panduan Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Instrumen Selam Aqua Jet SA 3995. Aqua Jet SA 3995 10 halaman. Hammer head

1. Attaching the Motor Unit to the Control Handle Bracket

Place the motor unit on a flat surface and attach the control handle bracket to the

motor unit by slotting the mounting post of the motor unit into the hole in control

handle bracket until it clicks firmly into place as indicated in diagram 5.

Fit the two black handles firmly into place as indicated in diagram 6.

Pull out the safety switch on the side of the motor driver to the 'ON' position as

diagram 5

indicated in diagram 7.

The motor cannot be started unless the safety switch is in the 'ON' position. The

safety switch should always be placed in the 'OFF' position when attaching or

removing the control bracket handle as indicated in diagram 7.

2. Using the Aqua Jet

Prior to using the Aqua Jet, ensure that the control bracket mechanism and

diagram 6

propeller are clean and free from obstructions.

Your Aqua Jet is now ready to use - simply put it into the water, squeeze the control

OFF

trigger and away you go! For optimum performance, your body should be in a

horizontal position as you glide through the water.

3. Removing the Motor Unit from the Control Handle Bracket

We recommend that the motor unit remain attached to the control handle bracket

diagram 7

once the Aqua Jet had been assembled.

In case the motor unit needs to be removed for storage or transport, place the motor

unit on a flat surface and remove the control handle bracket from the motor unit by

pressing firmly on the two black plastic buttons on the mounting post and

simultaneously pulling the control handle bracket entirely away from the motor unit

as indicated in diagram 8.

diagram 8