Aqua Lung Calypso Panduan Servis - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Servis untuk Instrumen Selam Aqua Lung Calypso. Aqua Lung Calypso 19 halaman. Second stage
Juga untuk Aqua Lung Calypso: Buletin Teknis (4 halaman), Panduan Pengguna (20 halaman), Panduan Pemeliharaan (20 halaman)

Halaman Cetak

RE-ASSEMBLY PROCEDURE

If the exhaust valve has been removed, pass the valve

tail through the hole in the casing from the outside and

pull gently until the notch is inside the casing. If it is a

new valve cut off any excess tail leaving about 5mm.

2. Fit a new O-ring (7) into the groove on the venturi knob

(6) and in the groove on the crown holder (22).

3. Fit the O-ring (20) onto the seat (21)

4. Insert the seat(21) into

the crown holder (22).

Use tool 125727 to screw

the seat fully home

against the crown holder.

Service manual Calypso second stage

5. Fit a new seat into the crown holder.

7. Fit the seat into the crown holder. This is to avoid

damaging the new crown. Screw the crown holder assembly

onto the insert (15) fitted with the poppet.

6. Fit a new square

poppet (16) using the

crown holder (18); then fit

the spring (17) into the

insert (15), then the

poppet (18).

8. Fit the lever (14).

The lever should be

opposite the injection

hole.