Aqua Lung EB001002 Panduan Pengguna - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Instrumen Selam Aqua Lung EB001002. Aqua Lung EB001002 20 halaman. Survival egress air

When SEA has been subjected to an aquatic environment but not used in a breathing

capacity please follow points 1 – 9 in full.

1. After each in-water use, SEA must be cleaned, inspected, and prepared for the

next use or storage.

2. As soon as possible after use in water, SEA should be soaked thoroughly. SEA is

to be pressurized before being submerged in warm tap water for at least one hour

(water temp should not exceed 49°C ). Soaking allows any salt and minerals to dissolve.

Before soaking, remove the mouthpiece cover to allow water into the second stage

and spring chamber.

3. After SEA has been properly soaked, it is important to thoroughly rinse the first

and second stages utilizing a pressurized stream of water. This will remove the salt

and mineral deposits that were loosened during soaking.

4. To dry SEA after use for storage, the demand valve shall be purged with the

breathing gas on while the demand valve is inverted and tipped downwards towards

the mouthpiece. This is to ensure that all residual water has been drained from inside

the demand valve if any had entered during the cleaning process. Store in a dry and

clean environment with circulating air.

5. Close the handwheel and completely depressurize SEA before storing or

transporting.

6. Due to the possibility of fire and exposure to extreme heat, SEA must be stored

according to the cylinder manufacturers recommended guidelines.

7. Store SEA completely dry, in a clean equipment box or sealed inside a plastic

bag. When possible, avoid storing it where it may be exposed to extreme heat or an

electric motor, which produces ozone. Prolonged exposure to extreme heat, ozone,

chlorine and ultraviolet rays can cause premature degradation to certain parts and

must be prevented.

8. When transporting SEA, take the necessary precautions to ensure that it is

surrounded by a protective cushion to prevent undue shock or impact.

9. Do not use any type of solvent or petroleum based substances to clean or lubricate

any part of SEA. Do not expose SEA to aerosol spray, as some aerosol propellants

attack or degrade rubber and plastic.