Bilanciai DD700 Manual - Halaman 3
Jelajahi secara online atau unduh pdf Manual untuk Aksesori Bilanciai DD700. Bilanciai DD700 5 halaman. Weighing terminal
Halaman Cetak
7.2
Error Messages
PROBLEM
Overload
Underload
-01-
-06-
-07-
-08-
-09-
-10-
-11-
-12-
-13-
-21-
Change the battery
USE AND MAINTENANCE MANUAL
CAUSE
The scale is
overloaded.
The balance is
negative at least 20
divisions.
1) 1) switch off the terminal and
Converter fault.
Scale connector
disconnected or
broken.
Digital cells fail
to respond
Serial number
error on digital
cell
Digital cell serial
number error in
system with
several load
cells
Digital cell serial
number error
Digital cell serial
number and
configuration
error
At least one cell
not configured
Digital cell
powering error
Powering error
in one digital cell
Cell with internal
temperature
off-limits (-40 -
100) °C
occasional
disconnection
Internal lithium
battery
discharged
83
REMEDY
Reduce the weight to a value
below the maximum scale
capacity.
If on completion of the operation
the display shows a value other
than zero , press
set the reading.
If the display is not zero-set on
pressing the key:
then switch it on again;
2) If the problem persists,
contact your Service Centre.
Contact Assistance Service.
Switch off the terminal and
check that the connector is
properly connected.
If necessary, disconnect and
then re-connect the connector.
Switch the terminal back on.
Switch the terminal off and
then on again.
Switch the terminal off and
then on again.
Switch the terminal off and
then on again.
Switch the terminal off and
then on again.
Switch the terminal off and
then on again.
Switch the terminal off and
then on again.
Switch the terminal off and
then on again.
Switch the terminal off and
then on again.
Switch the terminal off and
then on again.
temporary error
Contact Assistance Service.
to zero-