Bilco BL-Z Instalasi
Jelajahi secara online atau unduh pdf Instalasi untuk Tangga Bilco BL-Z. Bilco BL-Z 2 halaman. Retractable ladder
Halaman CetakBL-Z RETRACTABLE LADDER: INSTALLATION
BL-Z Stairways conform to DIN 4570, are manufactured from high strength die-cast aluminium alloy
components and have a load bearing of 200kgs. The stairway is
mul plex backboard (item 12); the height of the special backboard is variable, up to 2000mm high
by up to 1200mm wide.
The stairway is supplied with two heavy-duty counter-balanced springs (item 7), incorporated into
pivot brackets to ensure that the stairway can be raised and lowered with minimum effort.
All BL-Z stairway units are supplied with a telescopic handrail installed. Both sec ons are adjustable
and must be configured by the installer to suit their specific installa
of the handrail is
and retract when the ladder is opened and closed. The securing screws on the underside of the
handrail fixing brackets should be used to adjust the length of the top se
handrail doesn't interfere/conflict with the interior of the hatch box or the roof hatch above, while
also achieving the maximum length possible within the installa
The maximum fixing height from the floor to underside of the backboard is 3390mm. Selec
the correct stairway for the floor level to fixing height is determined as follows:
BL-Z 1 stairway supplied with 9 treads, 350mm wide x 140mm deep, to suit a floor to
underside of the backboard height of 2250mm - 2500mm.
BL-Z 2 stairway supplied with 10 treads, 350mm wide x 140mm deep, to suit a floor to
underside of the backboard height of 2501mm - 2790mm.
BL-Z 3 stairway supplied with 11 treads, 350mm wide x 140mm deep, to suit a floor to
underside of the backboard height of 2791mm - 3090mm.
BL-Z 4 stairway supplied with 12 treads, 300mm wide x 140mm deep, to suit a floor to
underside of the backboard height of 3091mm - 3390mm.
Installing the Stairway
First, check that the correct stairway has been received to suit the actual floor to
detailed above.
Please Note: It is not possible to stretch the stairway out to its full length un it has been
fixed in posi on.
Please Note: The stairway must be
We recommend that the backboard is securely fixed to the support structure using a minimum of 6
No. suitable screws (item 10), Ø8mm x 80mm, complete with Ø9mm washers (item 11).
The screws are not included with the stairway, as the correct screws/fixings depend on the actual
surface that the stairway is being fi
Once the stairway has been correctly fi
Bilco products are designed and fabricated to
consistently high quality standards to ensure
complete customer satisfaction.
whereas the top sec
d in the closed posi
to. Ensure the backboard is fixed to solid structural material.
d, it can then be lowered to the floor surface.
Bilco UK Ltd, Pavilion 7, Fornham Business Court, Hall Farm
+44 (0)1284 701 696 [email protected] www.bilcouk.co.uk
Bilco UK is part of the Access 360 portfolio of Tyman UK and Ireland
ed to a white coated
requirements. The bo
n slides within the
om sec
Ensuring that the
n.
to extend
n of
height as
I BL-Z BK TS Bilco UK Rev.B 2021