Aqua One AquaNano 30 Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Produk Perawatan Hewan Peliharaan Aqua One AquaNano 30. Aqua One AquaNano 30 7 halaman.
Juga untuk Aqua One AquaNano 30: Manual (13 halaman)

Aqua One AquaNano 30 Panduan Pengguna

Maintenance

DAILY:
Feed your fish as per instructions on your fish
food container.
Check temperature
Ensure all equipment is running correctly.
Ensure there is sufficient water in the
aquarium. When the water level drops due to
evaporation the return pump will begin to suck
air, resulting in fine bubbles being distributed
through the aquarium. When topping up
evaporated water, always use dechlorinated
tap water or suitably filtered water.
WEEKLY:
Test water parameters including pH, ammonia,
nitrite, nitrate and carbonate hardness. Use
quality test kits, Aqua One have a range of
test kits (sold separately) which will allow you
to easily and accurately monitor your water
quality.
Some
species
require
conditions. Please seek advice from your
marine aquarium specialist.
FORTNIGHTLY: 25% water change
What you will need: A bucket, gravel cleaner,
towel, algae scraper and water conditioner.
Fish do not need to be removed while
performing a water change.
1. Wash your hands.
2. Check the pH and temperature of both the
aquarium water and the new water. Make any
adjustments that need to be made to the new
water.
3. Once the water is ready to use, remove
the light unit and glass lid and place them
somewhere safe away from the water where
they will not be broken or damaged.
4. Turn the heater and pump off.
specific
water
7
6. Place a towel on the floor in front of the
aquarium to guard from water spillage.
7. Use an algae scraper and gently remove
any algae that is growing on the glass.
8. Using a gravel cleaner, remove 25% of
the aquarium water. Take note of how much
water is removed and be sure to have enough
prepared water to replace all that is removed.
9. Remove the sponges from the filter unit
and rinse them in the water that has been
removed from the aquarium. Never rinse the
sponge or ceramic noodles under tap water
as it will kill the beneficial bacteria that live on
the filter media.
10. Refill the aquarium using the prepared
water. Ensure there is sufficient water so that
the pump is fully submerged.
11. Turn the heater and pump back on.
12. Allow the aquarium to run for 30 minutes
then check the temperature and pH. Adjust if
necessary.
13. Replace the glass lid and light unit.
The filter unit can be removed for maintenance.
If it is being removed during a water change,
ensure the aquarium is not filled before the
filter is replaced as the displacement of water
when it is being placed back into the aquarium
may cause the aquarium to overflow. Push
the filter box into the correct position and hold
it down while the filter box fills with aquarium
water (water will enter via the pump). Once
the filter is in place, top the aquarium up to the
correct water level ensuring water conditioner
is used on the new water.
MONTHLY: Pump Maintenance
Follow the maintenance instructions in the
pump instruction manual to remove and clean
the impeller and impeller housing.
GB