Aqua One AquaReef 400 Manual - Halaman 6

Jelajahi secara online atau unduh pdf Manual untuk Produk Perawatan Hewan Peliharaan Aqua One AquaReef 400. Aqua One AquaReef 400 8 halaman. Series ii, aquarium
Juga untuk Aqua One AquaReef 400: Manual (8 halaman)

Halaman Cetak

Set Up Instructions

All plumbing components are already glued

into place except where threaded joints are

required for assembly into the aquarium or to

allow access for maintenance. Two people will

be required to connect the plumbing through

the base of the aquarium, one to access from

above the weir and one to hold pipes in place

below the aquarium.

1. Insert the threaded end of the drain pipe

(1) into the larger hole in the base of the weir.

Ensure the rubber grommet is placed between

the glass and the connection.

2. Attach the lower drain pipe (2) to the male

thread beneath the aquarium. Ensure a rubber

grommet is in place beneath the glass. Do

NOT overtighten, hand tightened is sufficient.

3. Repeat step 1 and 2 with the return pipes

(6 & 7). Ensure rubber grommets are used

on both sides of the glass and the threaded

elbow at the top of the return pipe is facing

towards the front of the aquarium.

4. Feed the lower elbow (3) through the lid

(4). The elbow should be facing the lower

drain pipe so they can be connected using the

barrel union.

5. Attach the flexible outlet (5) to the return

pipe. The threaded section should pass

through a hole in the overflow grill.

6. Ensure the hole in the top of the drain pipe

remains free, this will minimise noise caused

as water exits the aquarium.

7. Follow the instructions provided with the

return pump to install into the sump. Place

the pump in the position noted on page 5 and

use the elbow intake as described in the

instructions. A short length of flexible hose is

provided to connect the pump to the return

pipe (7). A hose clamp is also provided to

secure the hose onto the pipe.

8. Unpack the supplied filter media and place

in the locations shown on page 5. Place the

lid on the filter and connect the barrel union

(2 & 3)

9. Fill the aquarium with water such that the

water overflows into the sump and fills the last

section (where the return pump sits) to about

5cm above the maximum operating water

level mark. When running, the water level

should always remain above the minimum

operating water level mark.

10. The heater should be placed in the first

(left) section of the sump where the water

level is highest and stays constant.

NOTE: Plumbers tape is supplied on threaded

fittings; it is highly recommended that this be

replaced if the plumbing is disconnected at

any time.