CP Electronics MWS1A-PRM Panduan Produk - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Produk untuk Aksesori CP Electronics MWS1A-PRM. CP Electronics MWS1A-PRM 4 halaman. Microwave presence detector - wall mounted
Juga untuk CP Electronics MWS1A-PRM: Panduan Instalasi (16 halaman)

Halaman Cetak
Parameter
Default
0
Name
Value
SHIFT 1
On / Raise
On
Off / Lower
Off
Walk test
Off
On
Time Out
10 mins
1, 10 &
(Time
20
adjustment)
minutes
Lux on level
9
2, 5 & 7
(Switch
level on)
Lux off level
9
2, 5 & 7
(Switch
level off)
Sensitivity
9
1, 5 & 9
Defaults
Presence /
Presence Presence
Absence
Shift
The functionality of the MWS1A is controlled by a number of parameters which can be
changed or programmed by any of the following devices:
UHS5 Infrared Handset. See below for programmable functions.
UN-LCDHS Infrared Handset (with LCD). See user guide for full programming details.
For most basic programming operations the UHS5 handset can be used and the following
procedures are based on using this device.
Point the handset at the Sensor and send the required programming commands to the unit
as shown below.
Valid commands will be indicated by a red LED flash. See page 1 for details of other LED
responses.
Note: other functions on the UHS5 which are not shown below are not applicable to this
product.
Number of Shift key presses
1
2
3
SHIFT 2
SHIFT 1
SHIFT 2
SHIFT 1
SHIFT 2
SHIFT 1
Button Activation
Off
5, 15 &
30
minutes
4, 6 & 9
4, 6 & 9
3, 6 & 8
D
Absence
UHS5 Handset Graphics
SHIFT 2
Programming
Description
Turn lights on.
Turn lights off.
When set to On this causes a red LED to
flash on the sensor when it detects
movement. Use this feature to check for
adequate sensitivity levels.
Once the detector is turned on, this value
sets how long the lights will stay on once
movement has ceased.
Lux level setting to prevent the luminaires
being switched on if the ambient light level
is sufficient (adjustable between 1
and 9). The luminaires will always be
switched on at level 9.
Lux level setting to switch the luminaires off
during occupancy if the ambient light level
goes above the setting (adjustable between
1 and 9). Level 9 will always keep the lights
on. This setting can be used for "window
row switching".
Sensitivity level for detecting movement.
1 = low sensitivity
9 = high sensitivity
Returns the unit to the default settings.
Absence mode not implemented—do not
use.
Use this button to select the settings in red
and blue signified by the 'Shift 1' and 'Shift
2' LEDs
3