Aqua One Ocellaris 3000 Manual - Halaman 7
Jelajahi secara online atau unduh pdf Manual untuk Produk Perawatan Hewan Peliharaan Aqua One Ocellaris 3000. Aqua One Ocellaris 3000 13 halaman.
UV Maintenance (UV model only)
When performing maintenance on the filter, it is important
to clean the quartz glass sleeve and check that the UV
lamp is functioning in order to ensure optimal performance
from the filter unit.
Cleaning the quartz glass sleeve
1. Switch the filter off at the power outlet. Disconnect the
plug.
2. Place a towel or a shallow container under the canister
unit. This will prevent any water spilling onto your cabinet
or stand and damaging it.
3. Close the flow valve and open the locking lever.
Disconnect the tap set from the filter head unit.
4. Take the filter unit to the sink or wherever you intend to
clean your filter. Ensure the area is clean and free from
soaps and detergents.
5. Open the canister by lifting the 4 clips securing the head
unit in place.
6. Remove the head unit and turn it upside down. This will
give you access to the UV components.
7. Unscrew the UV cover. The UV cover can then be lifted
off.
8. Using a damp cloth, gentle wipe the quartz glass cover,
removing any debris that has accumulated on the glass.
Replacing the UV lamp
9. Unscrew the collar and lift it off the sleeve. Gently
remove the quartz sleeve from the UV lamp.
10. Pull the UV lamp from the socket.
11. Remove the rubber cushion from the UV lamp and
place it on the new lamp.
12. Re-assemble the unit in reverse order.
NOTE: The UV lamp will not operate unless the head
unit is secured to the filter body. A sensor under the
clip will allow the lamp to operate when the filter is fully
assembled. To check for UV lamp functionality, plug the
head unit in and switch the UV lamp on before replacing
the UV cover. Press the sensor to activate the lamp. DO
NOT look directly towards the lamp when doing this.
7
UV Cover
Collar
Quartz Glass Sleeve
Rubber Cushion
UV Lamp