Billi Quadra Plus Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Produk Pipa Billi Quadra Plus. Billi Quadra Plus 12 halaman. Xl, xt, xr tap options
Juga untuk Billi Quadra Plus: Panduan Instalasi (8 halaman), Panduan Instalasi (7 halaman)

Halaman Cetak
User guide
Billi Quadra & Quadra Plus.
Filter removal and
replacement instructions
Important note: Please ensure you remove the
foam packing under the filter before installing .
1 . Press or hold the "ON/OFF" Button until
the lights in the tap turn OFF .
2 . Hold filter and pull towards you slowly .
The top of the filter is in a hinged cradle
assembly . It should stop after approximately
30 degrees of travel .
3 . The filter can now be released from the
holding cradle by pulling down on the filter .
4 . Take care not to spill water in the base of
the tray . If so wipe gently with absorbent
paper towel .
5 . Install new filter(s) into the same location
by pushing all the way up into the cradle .
6 . Push filter(s) forward until perpendicular
to the base and locked in place .
7 . Unit will now begin an automatic flush cycle .
Tap lights will flash orange and water will
dispense from the cold side of the tap .
8 . When the flush cycles finishes, the unit
will automatically reset and return to the
previous operating mode . It is normal to
see the tap lights displaying a solid red light
and a flashing blue light . This indicates that
the chilled water is currently being chilled
and should return to a solid blue light
within 5 minutes .
9 . Check for any leaks from around the filter,
hosing or pipeworks .
10 . Replace the front cover .
9