Aqua One AquaStyle 980 Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Akuarium Aqua One AquaStyle 980. Aqua One AquaStyle 980 13 halaman. Aquarium
Juga untuk Aqua One AquaStyle 980: Petunjuk Perakitan (4 halaman), Panduan Memulai Cepat (2 halaman)

Halaman Cetak

Set Up Instructions

1. Remove Filter and Light Unit from the Aquarium

body.

2. Wash your hands and arms. It is very important to

remove dirt, moisturizer and other impurities. Do this

whenever you work on the aquarium.

3. Wash the following DO NOT WASH IN SOAP OR

DETERGENT.

Black Filter Sponge, Ceramic Noodles (Remove

noodles from plastic bag), Carbon Cartridge, Filter

Grid, Spray Bar, Intake Pipe, Strainer, Elbow, Filter

Unit, Glass Tank (Inside).

4. Connect the Intake Pipe and Strainer together.

5. Connect them to the bottom of the Power Head

which is connected to the base of the Filter Unit.

6. Place the filter grids in the bottom of the filter unit

followed by the ceramic noodles. Fig 3

7. Place the black filter sponges on top of the ceramic

noodles. Fig 3

8. Place the carbon cartridges on top of the black filter

sponges with the wool facing upwards. Fig 3

9. Connect the elbow in to the top of the power head.

The longer section of the elbow attaches over the outlet

of the power head. NOTE: This should be a tight fit.

Fig 1

10. Then connect the spray bar to the other end of

the elbow. Make sure the holes of the spray bar are

pointing down onto the carbon cartridges and that the

end of the spray bar has the cap fitted. Fig 1

11. Consider where you are going to place the

aquarium. Keep it away from direct light or areas with

large temperature fluctuations.

12. Place the aquarium on a flat level surface strong

enough to support its weight. We recommend a genuine

Aqua One Aquarium Cabinet (Sold separately) rather

than general household furniture.

13. Wash aquarium gravel. Place a portion of gravel

into a bucket, run water through & churn it over with

your hand until the water running out of the bucket

is clear. It is important to wash the gravel thoroughly.

Repeat this process several times until all the gravel

has been washed.

14. Place washed gravel over the base of the Aquarium.

15. At this stage place plastic plants, decorations and

heater (See Tips) in to the tank.

16. Fill the aquarium with tap water to the level indicated.

17. Use Aqua One quality Water Conditioner (Sold

separately) to remove harmful chemicals chlorine and

heave metals from tap water

18. Place the Filter Unit (Once complete) on top of the

Aquarium body towards the back.

19. Place the Light Unit on the front of the aquarium,

with the power cord passing through the Light Cord

Channel. Fig 3

21. Insure the holes of the spray bar are facing down

and that water is flowing through it.

22. Close the lid on the filter unit.

23. Turn the light switches on, ensure the lights work.

24. Test and adjust pH levels.

25. Allow the aquarium to stand for 5-7 days

before introducing a few hardy fish.

26. Seek advice from your retailer for correct fish

numbers and species compatibility.

TIPS

An Aqua One heater and Thermometer is required

if you are setting up a tropical or saltwater aquarium.

Refer to heater instructions for correct set up and

positioning.

Chlorine and other heavy metals will harm your

fish. Aqua One water conditioner will remove these

impurities and create a safe environment for your fish.

These products are available separately from your

local Aqua One retailer.

Note: This is only a guide! You should seek professional

advice from your aquarium specialist at the time of