Allied Systems SLN Panduan Pemeliharaan dan Servis Instalasi - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pemeliharaan dan Servis Instalasi untuk Peralatan Industri Allied Systems SLN. Allied Systems SLN 17 halaman.

Halaman Cetak

To Truck

To Clamp

Figure 4-4, Jumper Line Setup

3. Install the hoses from the truck to the attachment.

For specific hydraulic schematics and installation

information, please see your serial number specific

installation, maintenance and service manual, avail-

able online in the Manuals and Publications tab at

www.alliedsystems.com.

4. Install the lines from the truck's hydraulics to the

hydraulics of the attachment.

5. Inspect installation to ensure hoses are not kinked or

pinched between the truck carriage and attachment.

6. Operate the attachment continuously for several

minutes to determine that all hydraulic connections

are secure with no leaks.

7. With the mast in the vertical position, run the attach-

ment to the limit of all operations. After this procedure,

check that the truck's hydraulic reservoir oil level is at

the recommended level.

45-015, REV. 9/21

8. Before placing the attachment in operation inspect all

hoses and fittings for leaks and routing clearance. Be

sure to include clearance of jumper hoses to the mast.

Check the valve and cylinder for leaks, and check

cotter pins at each end of the cylinder for security.

9. After completing the installation, operate the attach-

ment without a load for several cycles to remove any

air in the hydraulic system. Test the attachment with a

load to make sure the attachment operates correctly.

Notice

Equipment damage hazard.

E q u i p m e n t d a m ag e , p e r fo r m a n c e

reduction, personal injury and/or loss of

warranty could result if any alterations are

made to the original attachment.

Consult with factory before altering

original equipment.