Allied Telesis AR400 Series Cara Mengkonfigurasi - Halaman 4

Jelajahi secara online atau unduh pdf Cara Mengkonfigurasi untuk Beralih Allied Telesis AR400 Series. Allied Telesis AR400 Series 6 halaman. How to set up pppoe between a linux client and access concentrator
Juga untuk Allied Telesis AR400 Series: Panduan Pemecahan Masalah (8 halaman), Pemecahan masalah (5 halaman), Panduan Pemasangan Cepat (8 halaman), Panduan Pemasangan Cepat (12 halaman), Manual Informasi Keselamatan (18 halaman), Bagaimana-Cara (8 halaman)

An example scenario for RIP over L2TP

Routing Considerations

A routing issue to consider in this set up is the fact that RIP is relatively slow to react to

route changes as it only updates, by default, every 30 seconds.

To improve the responsiveness of RIP you can alter the default timers for updating, flushing

and so on. You do need to keep in mind that if you lose some packets (quite possible across

a lossy Internet connection) some of your routes may flap too much. So the RIP timers need

to be adjusted to provide an optimal compromise between responsiveness and robustness.

In this particular example, the various RIP timers are set at half default value.

set ip riptimer update=15 invalid=90 holddown=60 flush=150

Consideration would need to be given to each specific set up to get an optimal balance when

adjusting these timers.

Page 4 | AlliedWare™ OS How To Note: Dynamic Routing over L2TP