Aqua Perfecta Pura Panduan Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Penyaringan Air Aqua Perfecta Pura. Aqua Perfecta Pura 12 halaman.

3 Required Tools

For installation, you need the following tools and materials:
Metal wrench 13mm / 14mm / 17mm
Scissors
Power Drill
Drill Bits 6mm / 12mm
PTFE Tape
Caution
This system is equipped with quick fitting connectors. With the quick fitting connectors, you can easily and safely
connect the PE tubes. Plug the tubes into the counterparts until you feel a click. When click occurs, then the tube is
correctly fastened in the anchoring device.
If you want to remove the tube again, you must, at first, remove the
retaining clip.
If the mains water pressure is higher than 6 bars, one pressure- reducing device must be installed before the inlet port of
the Pura.
4 RO Installation
1
Open the lid of the Pura housing.
Remove the combo cartridge filter from the Pura.
The combo cartridge filter has been loaded into the Pura
for transportation.
2
There are two small black rubber seals
on one side of the membrane.
3
In the center of the Pura, you can see a
for the membrane.
4
Insert the side which has the two small black rubber
seals into the circular slot.
And then, at the junction, you will see a small white plastic ring. Press the plastic
ring evenly then pull out the tube.
circular slot
AquaPerfecta.com
Open the lid
Two small black
rubber seals
Slot
Illustration without housing for better
understanding
0800 007 3737