AVPro Edge AC-CXWP-HDMO-100KIT Panduan Memulai Cepat - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pemancar AVPro Edge AC-CXWP-HDMO-100KIT. AVPro Edge AC-CXWP-HDMO-100KIT 4 halaman. Wall plate transmitters
Halaman CetakWhen using projectors RGB edid setting is recommended.
EDID can be managed using all wall-plate transmitters (VGA, HDMO, MDP) and the EX100-UHD-R3
receiver.
Copying EDID From Output:
With 70-Kits:
•
Connect category to TX/RX, HDMI to Display, and both RX and Display are powered
•
Turn dial to F on wall plate
With 100-Kits:
•
Connect category to TX/RX, HDMI to Display, and both RX and Display have power
•
Turn dial to F on RX
Troubleshooting
Having problems? Here are some general troubleshooting tips that may help:
(We recomend every integrator have the fox & hound troubleshooting kit. That way you have a
definitive answer when having problems with HDMI)
1. Try different HDMI cables. A defective HDMI cable can bring the entire system down.
2. If using short HDMI cables (.5m, 1m) try a longer cable. Some short HDMI cables do not sync
well.
3. Ensure you have the correct EDID settings selected.
4. Re-terminate the Category cable (even if a cable tester indicates that the cable is passing
signal).
5. Avoid RJ45EZ connectors
6. Check the Category cable length. It may be too long.
7. Remove any excess Category cable and be sure that it is not twisted or damaged.
8. If you are still having issues after troubleshooting, feel free to contact our Tech Support
department.
Have a question or need assistance?
EMAIL: [email protected]
:
Don't hesitate to contact us!
SUPPORT: +1 605-274-6055
USA TOLL FREE: 877-886-5112