AVPro Edge AC-MXNET-10G-SW24Q Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Jaringan AVPro Edge AC-MXNET-10G-SW24Q. AVPro Edge AC-MXNET-10G-SW24Q 8 halaman. The mxnet 10g sdvoe ecosystem

Halaman Cetak

1. Select the Transceiver Mode

The encoder and decoder (transmitter/receiver) are combined into one chassis with a simple toggle

switch to select application functionality. By default, the transceiver is set to decoder mode.

Flip the ENC/DEC SELECT toggle switch to set the transceiver to encoder or decoder mode.

(Front Panel)

AC-MXNET-10G-TCVR

To the right of the toggle switch is a blue LED that indicates the selected mode:

LED is on = Encoder mode

LED is off = Decoder mode

2. Select the Transceiver Port Type

10GbE copper and fiber ports on each transceiver allow flexibility to utilize the cabling that best fits

the specific installation.

For Category Cable Connections

Flip the SDVoE SELECT toggle switch to the 10G BASE-T setting, then flip the POE SELECT toggle

switch to the 10G setting.

(Rear Panel)

AC-MXNET-10G-TCVR

Connect the SDVoE 10G BASE-T port on the transceiver to a 10G Copper PoE port on the network

switch.

Connect the power supply to the network switch. By using this method, no additional cabling is

required to power the transceiver as it will be powered by the network switch via PoE (Power-over-

Ethernet).

Page 2 of 8

MXNET 10G SDVoE

Quick Start Guide