Aqua Select 832406 Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Tangga Aqua Select 832406. Aqua Select 832406 8 halaman. Gate system

• To complete installation, you will need the gate

latch assembly (AC GATELATH).

• There is a raised area of the latch mounting post

where you will secure the latch itself using

the (4) short screws supplied with the latch.

• Secure bar to either of the far openings on the

plate. Make sure bar lines up with latch so it

will close properly.

• Using two remaining short screws, secure plate to

the corner of the gate through two holes closest to

the latch.

STEP 4

• Slide latch mounting post (AC LATCHPT) onto hinge

mounting post (AC HINGEMT) on left side of step.

NOTE: It may be necessary to spread the back of

the latch mounting post open to install.

Picture here shows view from BEHIND step, the

NOTE

latch mounting post should face the same way

as the hinge post.

• The door stop (squared piece sticking out on gate)

should sit perfectly in recessed area of latch mounting

post (AC LATCHPT). If it is NOT sitting correctly, adjust

the height of the latch mounting post until it sits flush.

Once in place, secure post to mounting post using

(6) of the #10 x 1-1/4" screws through pre-marked

openings.

Do not install gate latch assembly until the gate is seated

NOTE

properly otherwise the latch will not catch.

STEP 5